Mid Plate Inspection NOTE: If replacement is required, always replace the pressure plate, mid plate, and flywheel as a set. 1. Inspect the mid plate surface for wear, cracks, and burning. 2. Inspect for warpage using a straight edge and feeler gauge. NOTE: Measure across the mid plate at three points. Standard: (New): 0.05 mm […]
Main Relay Description The main relay actually contains two individual relays. This relay is installed behind the passengers seat back panel. One relay is energized whenever the ignition is on which supplies the battery voltage to the ECU, power to the injectors, and power for the second relay. The second relay is energized for 2 […]
Slave Cylinder Removal 1. Disconnect the clutch hose from the slave cylinder. CAUTION: • Avoid spilling brake fluid on the painted sur- faces, as it may damage the finish. • Plug the end of the clutch hose with a shop towel to prevent brake fluid from coming out. 2. Remove the slave cylinder from the […]
Electronic Components Steering Angle Sensor Replacement Removal 1. Remove the steering column covers. Installation 1. Install the steering angle sensor by tightening two bolts, and make sure the adjusting shims are installed properly. CAUTION: Do not apply any grease or oil to the adjusting shim. Detect Part. ADJUSTING SHIMS 2. Disconnect the 5P connector from […]
Ignition Switch Test 1. Remove the dashboard lower cover (see next column). 2. Disconnect the 7-P connector from the floor wire harness. 3. Check for continuity between the terminals in each switch position according to the table. WHT (BAT-A) BLU/WHT (IG2-B) View from wire side BLK/WHT (ST) WHT/BLK (BAT-B) WHT/RED (ACC) Electrical Switch Replacement 1. […]
Emission Control System Positive Crankcase Ventilation System Description The Positive Crankcase Ventilation (PCV) system is designed to prevent blow-by gas from escaping to the atmosphere. The PCV valve contains a spring-loaded plunger. When the engine starts, the plunger in the PCV valve is lifted in proportion to intake manifold vacuum and the blow-by gas is […]
Rocker Arms and Shafts Clearance Measure both the intake rocker shafts and exhaust rocker shafts. 1. Measure diameter of shaft at first rocker location. MICROMETER Surface should be smooth. 2. Zero gauge to shaft diameter. MICROMETER CYLINDER BORE GAUGE 3. Measure inside diameter of rocker arm, and check for out-of-round condition. Rocker Arm-to-Shaft Clearance (Intake […]
Rear Damper Removal 1. Remove the rear wheels. 2. Remove the lower rear hatch glass trim. REAR HATCH GLASS TRIM 3. For NSX-T, remove the engine cover support rod from the strut brace, then position the end of the rod on the window lock mechanism to support the engine cover. NOTE: To prevent damage to […]
PGM-FI Main Relay Description The PGM-FI main relay actually contains two individual relays. The relay is located behind the passenger’s seat back panel. One relay is energized whenever the ignition is on which supplies the battery voltage to the ECM, power to the fuel injectors, and power for the second relay. The second relay is […]
Roof Side Lock Unit Replacement CAUTION: To prevent damage, place the roof on an appropriate pad. 1. Remove the roof. 2. Remove: • Roof front trim (see page 20-82) • Roof side trim (see page 20-82) • Roof side seal (see page 20-84) • Roof side retainer (see page 20-84) 3. Install the roof side […]