Fuel and Emission — Section 11 Clutch — Section 12 Main Menu Table of Contents − Fuel and Emission — Section 11 Unit of length: mm (in) MEASUREMENT STANDARD (NEW) Pressure regulator Pressure kPa (kg/cm2, psi) 330-370 (3.30-3.70, 47-53) Fuel tank Capacity l (US gal, imp gal) 70 (18.5, 15.4) Engine Fast idle rpm 1,100—1,900 […]
Month: August 2017
nsxb12004a.pdf
Clutch Pedal Adjustment NOTE: • To check the switch, see section 23. • The clutch is self-adjusting to compensate for wear. CAUTION: If there is no clearance between the master cylinder piston and push rod, the release bearing is held against the diaphragm spring, which can result in clutch slippage or other clutch problems. 1. […]
nsxb08008a.pdf
Oil Pump Removal/lnspection/lnstallation 1. Drain the engine oil. 2. Remove the timing belt (see page 6-15(’91-’93)or(’94-’96)). 3. Remove the dipstick and the pipe. 4. Remove the oil filter assembly. 5. Remove the oil pan. 6. Remove the oil screen. 7. Remove the baffle plate, 8. Remove the oil pass pipe and the joint. 9. Remove […]
nsxd11034a.pdf
Troubleshooting Self-diagnostic Procedures I. When the Malfunction Indicator Lamp (MIL) has been reported on, do the following: 1. Connect the Service Check Connector terminals with a jumper wire as shown (the Service Check Connector is located under the dash on the passenger side of the car). Turn the ignition switch ON. SERVICE CHECK CONNECTOR (2P) […]