Lighting System Retractable Headlight Control Unit Input Test Remove the rear bulkhead panels, and disconnect the 18-P connector from the control unit. Inspect the connector and socket terminals to be sure they are all making good contact. • If the terminals are bent, loose, or corroded, repair them as necessary, and recheck the system. • […]
CANADA Model Vehicle Identification Number Transmission Number Engine Number Vehicle Identification Number and Canadian Motor Vehicle Safety Standard Certification Paint Code Paint Code Attachments nsxa01003a (55 kB)
Troubleshooting Cruise Control NOTE: • The numbers in the table show the troubleshooting sequence. • Before troubleshooting: — Check the No. 5 (15 A) fuse in the under-dash fuse box, and the No. 29 (50 A) and No. 45 (20 A) fuses in the under- hood fuse/relay box. — Check that the horns sound. — […]
Mirror Removal Mirror Holder Replacement 1. Insert a Phillips screwdriver in the door mirror through the service hole, then loosen the actuator retaining screw. MIRROR ACTUATOR RETAINING SCREW 2. Pull the mirror holder out of the mirror housing. Disconnect the connector. ACTUATOR MIRROR HOLDERMIRROR HOUSING 3. Remove the actuator (see section 23). 4. Installation is […]
Emission Control System The emission control system includes a Three Way Catalytic Converter, Exhaust Gas Recirculation (EGR) system, Positive Crankcase Ventilation (PCV) system and Evaporative Emission (EVAP) control system. The emission control system is designed to meet federal and state emission standards. Tailpipe Emission 1. Starting the engine and warm it up to normal operating […]
Position Adjustment After installing the door, check for a flush fit with the body, then check for equal gap between the front, rear, and bottom door edges and the body. The door and body edges should also be parallel. Adjust at the door hinges as shown. CAUTION: Place a shop towel or rubber pad on […]
VALVE SEAT ROLLERRELIEF VALVE MAIN VALVE BODY 3-4 SHIFT VALVE VALVE CAP 1-2 SHIFT VALVE CHECK BALLS (7/32) 7 FILTER Replace. Install in this direction. 2-3 SHIFT VALVE ONE-WAY RELIEF VALVE MANUAL VALVE DETENT SPRING SPRING SEAT 6 x 1.0 mm MANUAL VALVE Replace. Main Valve Body Disassembly/Inspection/Reassembly Clean all parts thoroughly in solvent or […]
Troubleshooting TCS Indicator Light Temporary Driving Conditions: 1. The TCS indicator light will come on and the control unit memorizes the Diagnostic Trouble Code (DTC) under cer- tain temporary conditions: 2. If the TCS indicator light does not come back on after correcting the tire or tire pressure problem, the TCS system is OK. NOTE: […]
Seat Belts Inspection Retractor Inspection 1. With the retractor installed, check that the belt can be pulled out freely. 2. Make sure that the belt does not lock when the retractor is tilted over slowly to 15° from the mounted position. The belt should lock when the retractor is tilted over 40° CAUTION: Do not […]
Transmission Assembly Installation NOTE: • Check that the two dowel pins are installed in the clutch housing. • Use only Super High Temp Urea Grease (P/N 08798-9002). 1. Place the transmission on the transmission jack, and raise it to the engine level. 2. Set the release fork to the clutch housing. 3. Install the two […]