Categories
Body

nsxb20020a.pdf

Mirror
Removal Mirror Holder Replacement
1. Insert a Phillips screwdriver in the door mirror
through the service hole, then loosen the actuator
retaining screw.
MIRROR
ACTUATOR
RETAINING SCREW
2. Pull the mirror holder out of the mirror housing.
Disconnect the
connector.
ACTUATOR
MIRROR HOLDERMIRROR HOUSING
3. Remove the actuator (see section 23).
4. Installation is the reverse of the removal procedure.
: CORROSION RESISTANT NUT
4. Installation is the reverse of the removal procedure.
5. Check for water teaks.
NOTE: Do not use high-pressure water.
MOUNTING NUTS
6 x 1.0 mm
10 N·m (1.0 kg-m, 7.2 Ib-ft)
CONNECTOR
(Mirror side)
MIRROR
NOTE: Raise the glass fully.
1. Remove the door panel, and carefully remove the
plastic cover (see pages 20-7(’93-’96),6(’91-’92),
8(’93-’96),7(’91-’92).
2. Disconnect the connector.
3. Remove the mounting nuts from the hole in the
door while holding the mirror.
NOTE: Do not drop the mounting nuts inside the
door.

Attachments