Mid Plate Guide Initialization NOTE: • If the pressure plate mounting bolts are unscrewed, the mid plate guide must be initialized. • Initialize after tightening the pressure plate mount bolts. 1. Screw the 5 mm bolt into the back of the flywheel until it just touches the mid plate guide. 5 x 0.8 mm BOLT […]
EPS Control unit Replacement CAUTION: Be careful not to damage the SRS wire harnesses when servicing the control unit. 1. Remove the dashboard lower cover and glove box and disconnect the light connector. 3. Disconnect the connectors from the EPS control unit by removing the wire harness band. EPS CONTROL UNIT 4. Remove the power […]
Emission Control System Positive Crankcase Ventilation (PCV) System Description The Positive Crankcase Ventilation (PCV) system is designed to prevent blow-by gas from escaping to the atmosphere. The PCV valve contains a spring-loaded plunger. When the engine starts, the plunger in the PCV valve is lifted in proportion to intake manifold vacuum and the blow-by gas […]
Rotate pulley and Inspect belt. for wear. 1 . Remove the ignition coil covers and harness clamps. 2. Disconnect the connectors, then remove the ignition coils. 3. Remove the cylinder head covers. 4. Inspect the timing belt for cracks and coolant or oil soaking. NOTE: TDC MARK BLUE MARK ADJUSTING BOLT 43N.m (4.3 kg-m. 31 […]
Transmission Reassembly SHIFT LEVER 3. Install the oil seal, select arm and select lever in the clutch housing. OIL SEAL Replace. SELECT LEVER 4. Install the differential assembly in the clutch housing. DIFFERENTIAL ASSEMBLY (cont’d) 1. Install the oil seal, shift arm and shift lever in the transmission housing. 8 x 1.0 mm SPECIAL BOLT […]
Chassis and Paint Codes U.S.Model Vehicle Identification Number Transmission Number Engine Number Vehicle Identification Number and Federal Motor Vehicle Safety Standard Certification Paint Code Paint Code Attachments nsxa01002a (55 kB)
Slave Cylinder (Canada) Overhaul/Inspection Super High Temp Urea Grease (P/N 08798-9002). Brake Assembly Lube or equivalent rubber grease. SLAVE CYLINDER SPRING Install with small end facing piston. (Brake Assembly Lube) SLAVE CYLINDER BODY Inspect the cylinder wall for scoring and wear. (Brake Assembly Lube) BLEEDER SCREW 10 N-m (1.0 kg-m, 7 Ib-ft) SLAVE CYLINDER PISTON […]
Shift Fork, Synchro Sleeve Clearance Inspection 1. Measure the clearance between each shift fork and its matching synchro sleeve. Standard: 0.45-0.65 mm (0.018-0.026 in) Service Limit: 1.0 mm (0.039 in) SYNCHRO SLEEVE SHIFT FORK 2. If the clearance exceeds the service limit, measure the width of the shift fork fingers. Standard: 1st/2nd Shift Fork: 8.9-9.0 […]
Control Unit Input Test SRS components are located in this area. Review the SRS component locations, precautions, and procedures in the SRS section 24 before performing repairs or ser- vice. Remove the bulkhead panel, then disconnect the con- nectors from the ECM and make the following tests. Inspect the connector and socket terminals to be […]
Fluid Level Checking/Changing Checking NOTE: Check the fluid level with the engine at nor- mal operating temperature (the cooling fan comes on). 1. Park the car on level ground. Turn off the engine. 2. Remove the dipstick (yellow loop) from the transmission, and wipe it with a clean cloth. NOTE: Check the fluid level for […]