Fuel Supply System System Troubleshooting Guide NOTE: Across each row in the chart, the sub-systems that could be sources of a symptom are ranked in the order they should be inspected starting with . Find the symptom in the left column, read across to the most likely source, then refer to the page listed at […]
Lighting System Component Location Index RETRACTABLE HEADLIGHT CONTROL UNIT Input Test, page 23-174 DAYTIME RUNNING LIGHTS CONTROL UNIT (Canada) Test, page 23-176 SECURITY CONTROL UNIT Input Test, page 23-312 HIGH BEAM INDICATOR LIGHT (In the gauge assembly) Gauge Assembly, page 23-121 COMBINATION LIGHT SWITCH Test, page 23-177 Replacement, page 23-178 UNDER HOOD FUSE/RELAY BOX DIMMER […]
Cancel Unit Input Test 1. Remove the steering column covers. Disconnect the 10-P connector from the turn signal cancel unit. 2. Inspect the connector terminals to be sure they are all making good contact. If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system. If the terminals look OK, […]
Troubleshooting Troubleshooting Guide Main Menu Table of Contents Troubleshooting Troubleshooting Guide Related components a ≣ в ↼ e v O ‚— а: и E .‘3 g 3 o ä U “I ш o Ё ш g: ë Ф E Д ⋪ ↼ − − ä System Indicated g ш Ë ä š ë ë g […]
Replacement NOTE: Remove the access panel, then remove the short connector (RED). Disconnect the connec- tor between the airbag and cable reel, then con- nect the short connector (RED) to the airbag connector. AIRBAG CONNECTOR CABLE REEL CONNECTOR ACCESS PANEL SHORT CONNECTOR (RED) Connect the special tool to the cable reel connector. CABLE REEL CONNECTOR […]
Transmission Installation 1. Place the transmission on the transmission jack, and raise to the engine level. 2. Check that the 14 mm and 10 mm dowel pins are installed in the torque converter housing. 3. Install the 3 transmission housing mounting bolts. 4. Install the 3 rear transmission mounting bolts. 5. Loosen the front engine […]
Construction Features The reinforced parts are located as shown. : Reinforced parts. DASHBOARD UPPER CROSS MEMBER UPPER STIFFENER ROOF PANEL TRUNK FRONT CROSS MEMBER FLOOR CROSS MEMBER BULKHEAD CENTER PILLAR UPPER REINFORCEMENT CENTER PILLAR LOWER REINFORCEMENT LOWER STIFFENER FRONT SIDE SILL EXTENSION LOWER REINFORCEMENT Upper Reinforcement Upper stiffener Upper patch Outer panel Inner pillar Front […]
Disassembly/Reassembly NOTE: • The thrust needle bearing are the same size. • The needle bearing are the same size. Prior to reassembling, clean all the parts in solvent, dry them, and apply lubricant to any contact surface. 22 x 38 x 3 mm THRUST WASHER THRUST NEEDLE BEARING Inspect for wear and operation. REVERSE DRIVEN […]
Lighting System Component Location Index RETRACTABLE HEADLIGHT CONTROL UNIT Input Test, page 23-178 (’94-’96) (’91-’93) HIGH BEAM INDICATOR LIGHT (In the gauge assembly) Gauge Assembly, page 23-121 COMBINATION LIGHT SWITCH Test, page 23-181 Replacement, page 23-162 DAYTIME RUNNING LIGHTS CONTROL UNIT (Canada) Test, page 23-180 SECURITY CONTROL UNIT Input Test, page 23-312 (’94-’96) (’91-’93) UNDER-HOOD […]
Opener/Latch/Opener Cable Replacement 1. Remove the mounting bolts, then remove the hood release handle and disconnect the opener cable. 2. Remove the mounting bolts and cover, then remove the hood latch and disconnect the opener cable and hood switch connector. 3. Remove the left side inner fender, then pull out the opener cable. NOTE: • […]