Categories
Suspension

nsxe18021a.pdf

Removal 1. Remove the front wheel and bearing unit assembly (page 18-15). 2. Remove the splash guard from the knuckle. SPLASH GUARD 10 N·m (1.0 kg-m, 7 Ib-ft) 3 Remove the lower control arm guard. 10 N·m (1.0 kg-m, 7 Ib-ft) LOWER ARM GUARD (cont’d) Corrosion resistant bolt/nut COTTER PIN Replace. On reassembly, bend the […]

Categories
Electrical

nsxb23206a.pdf

Back-up Lights Component Location Index A/T GEAR POSITION SWITCH (Back-up light switch) Test, page 23-160 (’93-’96) (’91-’92). UNDER-DASH FUSE BOX BACK-UP LIGHT SWITCH (M/T) Test, page 23-208 (’93-’96) (’91-’92). BACK-UP LIGHTS Bulb replacement, page 23-206 Attachments nsxb23206a (40 kB)

Categories
Electrical

nsxb23231a.pdf

Removal CAUTION: Be careful not to damage the center air vent or clock. 1. Pull the clock out with your fingers (if necessary, use a screwdriver). 2. Disconnect the 4-P connector from the clock. 4-P CONNECTOR CENTER AIR VENT Terminals Terminal Wire Connects to CLOCK Attachments nsxb23231a (44 kB)

Categories
Heating, Ventilation and Air Conditioning

nsxb22066a.pdf

Aspirator Fan Test Connect battery power to the No. 3 terminal of the aspirator fan, and connect ground to the No. 4 terminal. The aspirator fan should run. Relay Test There should be continuity between the C and D terminals. There should be continuity between the A and B ter- minals when power and ground […]

Categories
Automatic Transmission

nsxd14142a.pdf

Torque Converter Housing Bearings Mainshaft Bearing Replacement 1. Drive out the mainshaft bearing and oil seal using the special tools as shown. 3. Install the new oil seal flush with the housing using the special tools as shown. DRIVER 07749–0010000 ATTACHMENT, 72 x 75 mm 07746–0010600 ATTACHMENT, 07947–6340500 TORQUE CONVERTER HOUSING 2. Drive in the […]

Categories
Steering

nsxb17064a.pdf

EPS Control Unit Replacement SRS components are located in this area. Review the SRS component locations, precautions, and procedures in the SRS section 24 before performing repairs or ser- vice. 1. Remove the dashboard lower cover. DASHBOARD LOWER COVER 2. Turn up the floor mat, and remove the speaker cover and speaker. SPEAKER COVER SPEAKER […]

Categories
Electrical

nsxb23318a.pdf

Security Alarm System Wiring Connections TRUNK KEY CYLINDER SWITCH REAR WIRE HARNESS RIGHT TAILLIGHT PASSENGER’S DOOR KEY CYLINDER SWITCH PASSENGER’S DOOR LOCK ACTUATOR ASSEMBLY DRIVER’S DOOR KEY CYLINDER SWITCH LEFT ROOF LOCK SWITCH NSX-T (open top) DRIVER’S DOOR LOCK ACTUATOR ASSEMBLY UNDER-HOOD RELAY BOX A (HORN RELAY) FLOOR WIRE HARNESS DRIVER’S DOOR WIRE HARNESS RIGHT […]

Categories
Fuel & Emissions

nsxb11138a.pdf

Fuel Supply System Fuel Filter Do not smoke while working on fuel sys- tem. Keep open flame away from your work area. The fuel filter should be replaced every 4 years or 60,000 miles (96,000 km), whichever comes first, or whenever the fuel pressure drops below the specified value [324 – 363 kPa (3.3 – […]

Categories
Cylinder Head & Valve Train

nsxb06013a.pdf

Timing Belt Illustrated Index NOTE: Refer to page 6-18 (’91-’93) or (’94-’96) for positioning crankshaft and pulley before installing the belt. if it is to be reused, mark the direction of rotation on the belt before removing. Do not use the middle cover and lower cover for storing removed items. Clean the middle cover and […]

Categories
Electrical

nsxe23071a.pdf

Steering Lock Replacement SRS wire harness is routed near the steering lock assembly. CAUTION: All SRS electrical wiring harnesses are covered with yellow outer insulation. Before disconnecting the SRS wire harness, install the short connector on the airbag (see page 23-323). Replace the entire affected SRS harness assembly if it has an open circuit or […]