EPS Control Unit
Replacement
SRS components are located in this area. Review the
SRS component locations, precautions, and procedures
in the SRS section 24 before performing repairs or ser-
vice.
1. Remove the dashboard lower cover.
DASHBOARD LOWER COVER
2. Turn up the floor mat, and remove the speaker cover
and speaker.
SPEAKER COVER
SPEAKER
3. Disconnect the connectors from the EPS control
unit, then remove it.
10 N-m (1.0 kg-m, 7 Ib-ft)
3P CONNECTORS
EPS CONTROL UNIT
18P CONNECTOR
10 N-m (1.0 kg-m, 7 Ib-ft)
4. Installation is the reverse of removal procedure.
NOTE: After installation, start the engine and make
sure that the EPS indicator light goes off.
Replacement
SRS components are located in this area. Review the
SRS component locations, precautions, and procedures
in the SRS section 24 before performing repairs or ser-
vice.
1. Remove the dashboard lower cover.
DASHBOARD LOWER COVER
2. Turn up the floor mat, and remove the speaker cover
and speaker.
SPEAKER COVER
SPEAKER
3. Disconnect the connectors from the EPS control
unit, then remove it.
10 N-m (1.0 kg-m, 7 Ib-ft)
3P CONNECTORS
EPS CONTROL UNIT
18P CONNECTOR
10 N-m (1.0 kg-m, 7 Ib-ft)
4. Installation is the reverse of removal procedure.
NOTE: After installation, start the engine and make
sure that the EPS indicator light goes off.