SRS wire harnesses are routed near the carpet. CAUTION: All SRS electrical wiring harnesses are covered with yellow outer insulation. Before disconnecting the SRS wire harness, install the short connector on the airbag (see page 23-323). Replace the entire effected SRS harness assembly if it has an open circuit or damaged wiring. 1. To remove […]
Throttle Body Description The throttle body is of the single-barrel side-draft type. The lower portion of the throttle valve is heated by engine coolant which is fed from the cylinder head. The idle adjusting screw, which increases/decreases bypass air, and the evaporative emission (EVAP) control canister port are located on the top of the throttle […]
Cylinder Heads Installation Install the cylinder heads in the reverse order of removal: • Always use new head gaskets. • Cylinder heads and engine block surface must be clean. • Turn the crankshaft so that No. 1 piston is at TDC (see page 6-19). • Do not use the middle cover and lower cover for […]
Front Brake Pads Inspection/Replacement • Never use an air hose or dry brush to clean brake assemblies. • Use an OSHA-approved vacuum cleaner to avoid breathing brake dust. 1. Loosen the front wheel nuts slightly, then raise each side of the car and support it on safety stands (see page 1-9 through 1-11). Remove the […]
Air Intake System Throttle Body (cont’d) Disassembly THROTTLE CABLE 22 N·m (2.2 kg-m. 16 Ib-ft) CAUTION: The throttle stop screw in non-adjustable. After reassembly, adjust the throttle cable (page 11-113). After replacement, adjust the idle speed (page 11-84). DASHPOT DIAPHRAGM Test, page 11-118 THROTTLE ANGLE SENSOR IDLE ADJUSTING SCREW O-RING Replace Attachments nsxe11116a (121 kB)
Headlights Bulb Replacement CAUTION: • Halogen headlights can become very hot in use; do not touch them or the attaching hardware immediately after they have been turned off. • Do not try to replace or clean the headlights with the lights on. 1. Remove the bulb cap. BULB (HI: 60 W/LO: 51 W) BULB CAP […]
Intake Air Bypass (IAB) Control Valve Testing CAUTION: Do not adjust the IAB control valve full- close screw. It was preset at the factory. 1. Check the IAB control valve shaft for binding or sticking. 2. Check the IAB control valve for smooth movement. 3. Check that of the IAB control valve is in close […]
Carpet Replacement SRS wire harnesses are routed near the carpet. CAUTION: Remove: 2. Detach the clips at the front edge (passenger’s). 3, Remove the console carpet attaching screw from the heater unit (passenger’s). 4. Disconnect the air duct (driver’s) and air vent, then remove the carpet hooks from the dashboard inside screws. DASHBOARD INSIDE SCREW […]
System Description The idle speed of the engine is controlled by the Electronic Air Control Valve (EACV). The valve changes the amount of air bypassing into the intake manifold in response to electric current sent from the ECU. When the EACV is activated, the valve opens to maintain the proper idle speed. BLU/RED EACV ECU […]
Troubleshooting Engine Control Module Terminal Arrangement ECM CONNECTOR A (26P) ECM CONNECTOR A (26P) TERMINAL SIDE OF MALE TERMINALS NOTE: Standard battery voltage is 12 V. ECM CONNECTOR B (16P) ECM CONNECTOR B (16P) TERMINAL SIDE OF MALE TERMINALS NOTE: Standard battery voltage is 12 V. *: M/T Main Menu Table of Contents O 1 […]