Variable Valve Timing and Valve Lift Electronic Control System (VTEC) Outline The engine is equipped with multiple cam lobes per cylinder, providing one valve timing and lift profile at low speed and a different profile at high speed. Switch-over from one profile to the other is controlled electronially, and is selected by monitoring current engine […]
Power Door Locks Control Unit Input Test Remove the glove box, then disconnect the 18-P con- nector from the control unit. Inspect the connector terminals to be sure they are all making good contact. If the terminals are bent, loose, or corroded, repair them as necessary, and recheck the system. If the terminals look OK, […]
Engine Coolant Refilling and Bleeding CAUTION: When pouring engine coolant, be sure to shut the relay box lid and not let coolant spill on the electrical parts or the paint. If any coolant spills, rinse it off immediately. NOTE: • Perform this maintenance when the engine is cool. • Before replacing the coolant, turn the […]
5. Remove the four screws from the headlight switch. HEADLIGHT SWITCH 10-P CONNECTOR 16-P CONNECTOR 6. Disconnect the 10-P connector from the turn signal cancel unit, then remove the headlight switch and turn signal switch. 7. Separate the headlight switch from the turn signal switch. 8. If necessary, remove the turn signal cancel unit and […]
Inspection SELF-LOCKING NUT 10 x 1.25 Replace. DAMPER MOUNTING RUBBER SELF-LOCKING NUT 10 x 1.25 mm Replace. 54 N-m (5.4 kg-m, 39 Ib-ft) DAMPER MOUNTING WASHER DAMPER MOUNTING COLLAR DAMPER MOUNTING BASE BUMP STOP PLATE DAMPER MOUNTING RUBBER SPRING MOUNTING RUBBER Check for damage and cracks. BUMP STOP PLATE DUST COVER SLEEVE Check for damage. […]
Bearing Replacement NOTE: • The bearing and outer race should be replaced as a set. • Inspect and adjust the bearing preload whenever the bearing is replaced. 1. Remove the tapered roller bearings using the bear- ing pullers. BEARING PULLER (Commercially available) TAPERED ROLLER BEARING BEARING PULLER (Commercially available) TAPERED ROLLER BEARING 2. Install the […]
Steering Wheel Disassembly/Reassembly Store a removed airbag assembly with the pad surface up. If the airbag is improperly stored face down, accidental deployment could propel the unit with enough force to cause serious injury. NOTE: If an intact airbag assembly has been removed from a scrapped car or has been found defective or dam- aged […]
7. Slip a 6 mm steel washer and the correct driver at- tachment over the end of the driver (The washer will absorb some of the impact and extend the life of the driver). DRIVER 6 mm WASHER ATTACHMENT 8. Install the new guide(s) from the camshaft side of the head; drive each one in […]
8-4 8-5 8-4, 10-5 23-96 13-2a 14-105 19-6, 19-9 19-17, 19-19 1: Refer to Base Service Manual (’95 NSX, P/N 61SL004) 2: Measured between the rocker arm and camshaft. 3: Do not adjust the gap, replace the spark plug if it is out of spec. Follow the Normal Conditions Maintenance Schedule if the severe driving […]
Idle Control System Clutch Switch Signal (M/T) This signals the ECM when the clutch is engaged. Inspection of clutch switch signal. Check for an open in the circuit: 1. Turn the ignition switch ON (II). 2. Measure voltage between ECM connector terminals C4 and A26. Is voltage less than 1.0 V? Check for short in […]