Cruise Control Main Switch Replacement CAUTION: All SRS electrical wiring harnesses are covered with yellow outer insulation. Before disconnecting the SRS wire harness, install the short connector on the airbag (see page 23-323). Replace the entire affected SRS harness assembly if it has an open circuit or damaged wiring. 1. Remove the dashboard lower cover […]
Rocker Arms Manual Inspection 1. Remove the ignition coil covers (page 6-23). 2. Remove the ignition coils (page 6-23). 3. Remove the cylinder head covers (page 6-3). 4. Set the No. 1 piston at top dead center (TDC) (page 6-26). 5. Push the mid rocker arm on the No.1 cylinder manually. 6. Check that the […]
Steering Lock Removal/Installation SRS components are located in this area. Review the SRS component locations, precautions, and procedures in the SRS section 24 before performing repairs or service. 1. Remove the dashboard lower cover, and disconnect the connectors. 2. Remove the dashboard lower pad. DASHBOARD LOWER COVER 3. Remove the tilt cover. DASHBOARD LOWER PAD […]
Steering — Section 17 Standards and Service Limits Suspension — Section 18 Brakes — Section 19 M/T: Manual Transmission A/T: Automatic Transmission Attachments nsxb03012a (51 kB)
Standards and Service Limits Steering — Section 17 Suspension — Section 18 Brakes – Section 19 M/T: Manual Transmission A/T: Automatic Transmission Attachments nsxa03010a (54 kB)
Electronic Components TCS Control Unit Replacement 1. Remove the left rear trim panel and rear upper trim panel (see section 20). 2. Remove the wire harness bracket. 3. Disconnect the TCS control unit connectors. 4. Remove the TCS control unit. TCS CONTROL UNIT CONNECTORS WIRE HARNESS BRACKET 5. Install the TCS control unit in the […]
Evaporator Temperature Sensor Removal Give the evaporator temperature sensor a quarter turn, then pull out to remove it. EVAPORATOR TEMPERATURE SENSOR Test Compare the resistance reading between the terminals of the evaporator temperature sensor with specification shown in the following graph: It should be within specification. NOTE: Dip the sensor in ice water, and measure […]
Pressure Plate, Clutch Disc, Mid Plate Removal 1. Install the special tools. RING GEAR HOLDER 07LAB – PV00100 or 07924 – PD20003 ADJUSTER NUT ADJUSTER BOLT BOLT ENGINE BLOCK NUT WASHER 2. To prevent warping, unscrew the pressure plate mounting bolts in a crisscross pattern in several steps, then remove the pressure plate and the […]
Intermediate Shaft Reassembly 1. Press the intermediate shaft bearing into the bear- ing support using the special tools. Press DRIVER 07749-0010000 OIL SEAL DRIVER 07GAD-PG40100 BEARING Replace. HUB DIS/ASSEMBLY BASE 07GAF-SD40700 2. Seat the internal circlip in the groove of the bearing support. CAUTION: Install the circlip with the radiused side facing out. INTERNAL CIRCLIP […]
Drive By Wire System System Description The Drive By Wire System is an electronic throttle control system. This system consists of the throttle valve control motor and Throttle Position (TP) sensor assembled in Throttle Body (TB), the accelerator position sensor, and the Engine Control Module (ECM). To THROTTLE VALVE CONTROL MOTOR RELAY THROTTLE VALVE CONTROL […]