PGM-FI System Troubleshooting Flowchart Engine Control Module (ECM) (cont’d) Malfunction Indicator Lamp (MIL) stays on after two seconds. Turn the ignition switch ON. Connect the service check con- nector terminals with a jumper wire. Does the MIL indicate any Diagnostic Trouble Code (DTC)? Remove the jumper wire from the service check connector. Try to start […]
Description Hydraulic Flow General of Hydraulic Pressure Oil Pump Regulator Valve Distribution of Hydrualic Pressure Manual Valve Throttle Valve B 1-2 Shift Valve 2-3 Shift Valve 3-4 Shift Valve to select Line Pressure Throttle B Pressure Clutch Pressure Servo Valve Throttle ValveLine Pressure As the engine turns, the oil pump also starts to operate. Automatic […]
Ignition Coil Test 1. With the ignition switch OFF, remove the ignition coil. 2. Using an ohmmeter, measure resistance between the terminals. Replace the coil if the resistance is not within specifications. NOTE: Resistance will vary with the coil temperature; specification is at 77°F (25°C). Primary Winding Resistance (Between the A and B terminals): 0.9—1.1 […]
Radiator and Condenser Fan Controls Control Unit Terminals THROTTLE VALVE CONTROL MOTOR RELAY Wire Terminal Color Connects to 1. Disconnect the 3-P connector from the resistor. RADIATOR 3-P CONNECTOR FAN RESISTOR NOT USED 2. Using an ohmmeter, measure resistance between the A and B terminals. Replace the resistor if the resistance is not within specifications. […]
Front Turn Signal/Front Parking Lights Replacement 1. Remove the screw and pull the light assembly out of the front bumper. SCREW 2. Disconnect the 2-P connectors from the bulb sockets. 2-P CONNECTORS FRONT PARKING LIGHT BULB (5W) BULB SOCKET FRONT TURN SIGNAL LIGHT BULB (45CP) HOUSING 3. Turn the bulb sockets 45° counterclockwise to re- […]
Expansion Tank Cap Testing 1. Remove the expansion tank cap, wet its seal with engine coolant, then install it on the pressure tester. 2. Apply a pressure of 95-125 kPa (0.95-1.25 kg/cm2, 14-18 psi). 3. Check for a drop in pressure. PRESSURE TESTER ADAPTOR (for 32 mm neck) EXPANSION TANK CAP Testing 1. Wait until […]
Cylinder Head/Valve Train ’91−’94 Models Special Tools 6−2. . . . . . . . . . . . . . . . . . . . . . . . . . . VTEC Solenoid Valve Inspection 6−20. . . . . . . . . Rocker Arms Manual Inspection 6−52. . . . […]
2. Disconnect the 5-P connector from the steering an- gle sensor. 3. Remove the steering angle sensor mounting bolts, then remove the steering angle sensor. NOTE: Take care not to drop the adjusting shim used between the steering angle sensor and sensor mounting bracket. CAUTION: Take care not to damage or drop the steering angle […]
Ball Joint Boot Replacement NOTE: The upper control arm ball joint is attached with the boot retainer to improve the sealing efficiency of the boot. 1. Remove the set ring and boot. 2. Remove the retainer (upper ball joint only). TWO-JAW PULLER (Commercially available) SET RING BOOT RETAINER NOTE: Do not damage the tapered section […]
Brakes Conventional Brake System Special Tools 19−2. . . . . . . . . . . . . . . . . Component Location Index 19−3. . . . Pedal Height Adjustment 19−4. . . . . . Parking Break Adjustment 19−4. . . . . Front Brakes Index/Inspection 19−5. . . . . […]