Side Marker/Turn Signal/Hazard Flasher System Hazard Warning Switch Replacement SRS components are located in this area. Review the SRS component locations, precautions, and procedures in the SRS section 24 before performing repairs or ser- vice. 1. Remove the dashboard lower cover, and disconnect the connectors. 2. Remove the dashboard lower pad. DASHBOARD LOWER COVER 3. […]
Power Unit Torque/Inspection CAUTION: • Do not attempt to disassemble the power unit ex- cept for those components shown in this illustration. • Do not spill brake fluid on the car; it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water. • To prevent spills, cover the […]
Cruise Control Description The cruise control system uses mechanically and electri- cally operated devices to maintain vehicle speed at a setting selected by the driver. The ECM receives command signals from the cruise con- trol main switch and the cruise control set/resume switch. It receives information about operating conditions from the brake switch, vehicle speed […]
Main Bearings Clearance 1. To check main bearing-to-journal oil clearance, remove the main caps and bearing halves. 2. Clean each main journal and bearing half with a clean shop towel. 3. Place one strip of plastigage across each main jour- nal. NOTE: If the engine is still in the car when you bolt the main […]
Symptom-to-Component Chart Hydraulic System Main Menu Table of Contents Symptom-to-Component Chart Hydraulic System Check these items on the Check these items on the At disassembly, large particles of metal are found on magnet. SYMPTOM PROBABLE CAUSE LIST NOTES CHART Engine runs, but car does not move in any gear. 1, 6, 7, 16 K, L, […]
Air Cleaner (ACL) ACL Element Replacement ACL HOUSING COVER ACL ELEMENT Replace ACL element every 30,000 miles (48,000 km) or 24 months. Clean ACL element every 7,500 miles (12,000 km) or 6 months under dusty conditions, rough or muddy roods. INTAKE AIR DUCT RESONATOR ACL HOUSING Attachments nsxd11129a (182 kB)
Troubleshooting NOTE: The numbers in the table show the troubleshooting sequence. Intermittent Relay Test 1. Remove the wiper intermittent relay from sub relay box B. 2. There should be continuity between the A and C ter- minals when the battery is connected to the E and F terminals. The should be continuity between the B […]
Emission Control System System Troubleshooting Guide NOTE: Across each row in the chart, the sub-systems that could be sources of a symptom are ranked in the order they should be inspected starting with . Find the symptom in the left column, read across to the most likely source, then refer to the page listed at […]
Recirculation Control Motor Replacement 1. Remove the blower unit (see page 22-67) 2. Remove the three screws and the recirculation con- trol motor cover from the blower unit. RECIRCULATION CONTROL MOTOR COVER 3. Remove the three screws and the recirculation con- trol motor. RECIRCULATION CONTROL MOTOR 4. Install the recirculation control motor in the reverse […]
Idle Control System Troubleshooting Flowchart Neutral Switch Signal (M/T) This signals the ECM when the transmission is in neutral. Inspection of neutral switch signal. Connect the test harness be- tween the ECM and connectors (see page 11-37). Turn the ignition switch ON. Measure voltage between B7 (+) terminal and A26 (-) terminal in neutral position. […]