Side Marker/Turn Signal/Hazard Flasher System
Hazard Warning Switch Replacement
SRS components are located in this area. Review the
SRS component locations, precautions, and procedures
in the SRS section 24 before performing repairs or ser-
vice.
1. Remove the dashboard lower cover, and disconnect
the connectors.
2. Remove the dashboard lower pad.
DASHBOARD LOWER
COVER
3. Remove the tilt cover.
DASHBOARD LOWER
PAD
TILT COVER
4. Remove the steering column covers.
NOTE: Be careful not to damage the steering column
covers.
UPPER COVER
LOWER COVER
5. Disconnect the 20-P, 4-P, and 5-P connectors.
CAUTION: Be careful not to damage the SRS wire
harness.
6. Remove the six screws, then remove the hazard
warning-wiper switch assembly.
HAZARD
WARNING
SWITCH
20-P CONNECTOR
Hazard Warning Switch Replacement
SRS components are located in this area. Review the
SRS component locations, precautions, and procedures
in the SRS section 24 before performing repairs or ser-
vice.
1. Remove the dashboard lower cover, and disconnect
the connectors.
2. Remove the dashboard lower pad.
DASHBOARD LOWER
COVER
3. Remove the tilt cover.
DASHBOARD LOWER
PAD
TILT COVER
4. Remove the steering column covers.
NOTE: Be careful not to damage the steering column
covers.
UPPER COVER
LOWER COVER
5. Disconnect the 20-P, 4-P, and 5-P connectors.
CAUTION: Be careful not to damage the SRS wire
harness.
6. Remove the six screws, then remove the hazard
warning-wiper switch assembly.
HAZARD
WARNING
SWITCH
20-P CONNECTOR
7. Remove the screws, then separate the hazard warn-
ing switch from the other switches.
HAZARD WARNING
SWITCH
8. If necessary, remove the hazard warning switch
bulb.
HAZARD WARNING SWITCH
BULB (0.91