Runout 1. Raise the car off the ground, and support it with safe- ty stands in the proper locations (see section 1). 2. Place the dial gauge on each front and rear wheel rim, and turn the wheel slowly by hand. Check the axial and radial runout for front/rear wheel. Front and Rear Wheel Axial […]
Replacement 1. Remove the flywheel mounting bolts in a criss- cross pattern in several steps, and remove the flywheel. MOUNTING BOLTS FLYWHEEL RING GEAR HOLDER 07LAB – PV00100 or 07924 – PD20003 2. Remove the ball bearing from the flywheel. DRIFT PUNCH FLYWHEEL BALL BEARING 3. Drive the new ball bearing into the flywheel using […]
Pressure Plate Inspection NOTE: If replacement is required, always replace the pressure plate, mid plate, and flywheel as a set. 1. Inspect the pressure plate surface for wear, cracks, and burning. 2. Inspect the fingers of the diaphragm spring for wear at the release bearing contact area. 3. Inspect for warpage using a straight edge […]
Taillights Replacement 1. Open the trunk lid, and remove the rear trim panel. 2. Disconnect the 8-P connector and 2-P connector from the taillight assembly. 3. Disconnect the 2-P connector from the trunk key cylinder switch. 8-P CONNECTOR 2-P CONNECTOR TRUNK KEY CYLINDER CONNECTOR REAR TRIM PANEL 4. Remove the four mounting nuts and rear […]
Starter Brush Holder Test 1. Check that there is no continuity between the and brush holders. If continuity exists, replace the brush holder assembly. BRUSH HOLDER BRUSH HOLDER BRUSH HOLDER 2. Insert the brush into the brush holder, and bring the brush into contact with the commutator, then at- tach a spring scale to the […]
Idle Control System Troubleshooting Flowchart Automatic Transaxle (A/T) Gear Position Signal This signals the ECM when the transmission is in Neutral or Park. Inspection of A/T gear position signal. Turn the ignition switch ON. Observe the A/T gear position in- dicator and select each position separately. Does the indicator light properly? Turn the ignition switch […]
Transmission Assembly Removal Make sure lifts are placed properly, and hoist brackets are attached to correct positions (see section 1). CAUTION: Use fender covers to avoid damaging painted surfaces. 1. Check and record the rear wheel alignment (see section 18). 2. Disconnect the battery negative (-) and positive (+) cables from the battery. 3. Drain […]
Emission Control System System Troubleshooting Guide NOTE: Across each row in the chart, the systems that could be sources of a symptom are ranked in the order they should be inspected starting with . Find the symptom in the left column, read across to the most likely source, then refer to the page listed at […]
DRIVEN GEAR Inspect teeth for wear or damage. DRIVE GEAR Inspect teeth for wear or damage. FEELER GAUGE DRIVEN GEAR STRAIGHT EDGE VALVE BODY 2. Measure the side clearance of the drive and driven gears. Pump Gears Side (Radial) Clearance: Standard (New): Drive gear (diameter) 3. Remove the shaft then measure the thrust clearance of […]
Special Tools Ref. No. Tool Number A973X-041 -XXXXX KS-AHM-32-003 07LAJ-PT3010A 07MAJ-PR70100 07JAZ-001000A 07406-0040001 Page Reference 11-62,116, 131,135,137, 146,148,154 11-37,50,55 11-37 11-37 11-156,157 11-106,113 Description Vacuum Pump/Gauge Digital Multimeter Test Harness Test Harness Vacuum/Pressure Gauge 0—4 in. Hg Fuel Pressure Gauge Qty 1 1 1 1 1 1 Attachments nsxd11002a (179 kB)