Under-dash Fuse Box Removal/Installation SRS components are located in this area. Review the SRS component locations, precautions, and procedures in the SRS section 24 before performing repairs or service. Removal: 1. Disconnect both the negative cable and positive cable from the battery. 2. Carefully remove the side sill pad (pull it up, rear end first). […]
Construction Features • Mid-engine car with ground-hugging, full-forward canopy design. • The lower body is AH-PO for greater resistance to corrosion and collision damage. • Outer panels, (except the roof) are constructed of individual panels to allow more convenient and economical repairs. • In considerations of rigidity, surface smoothness and simultaneous body painting, the trunk […]
Rear Pillar Seal/Retainer Replacement NOTE: • When the rear pillar seal has been removed, and/or it is damaged, replace it with new one. • Have an assistant help replace the rear pillar seal. 1. Remove the roof. 2. Remove the rear roof rail trim (see page 20-80). 3. Detach the clips from the bottom of […]
Fuel Supply System Injector Resistor Description The resistor lowers the current supplied to the injectors to prevent damage to the injector coils. This allows a faster response time of the injectors. Testing 1. Disconnect the resistor connector. 2. Check for resistance between each of the resistor terminals (b, c, d, e, f and g) and […]
Inspection : Thoroughly pack the inboard joint and outboard joint with joint grease included in the new joint boot set. Grease Quantity: NOTE: Mark the rollers and roller grooves during disassembly to ensure proper positioning during reassembly. Spline direction INBOARD JOINT Check splines for wear and damage. Check inside bore for wear. Inspect for cracks. […]
Test 1. Connect battery power to the No. 1 terminal of the air mix control motor, then connect ground to the No. 2 terminal; the air mix control motor should run, and stop at HOT, If it doesn’t, reverse the connections; the air mix control motor should run, and stop at COOL. NOTE: If the […]
Steering Column Inspection STEERING COLUMN ASSEMBLY 8 mm FLANGE NUTS 16 N·m (1.6 kg-m, 12 Ib-ft) 8 mm BOLTS 22 N·m (2.2 kg-m, 16 Ib-ft) CLAMPS STEERING JOINT COVER NOTE: Check the telescopic mechanism, tilt mechanism, and steering joint bearings or steering shaft for movement and damage. Replace as an assembly if damaged or faulty. […]
Fuel Supply System Fuel Pump Description Because of its compact impeller design, the fuel pump is installed inside the fuel tank, thereby saving space and simplifying the fuel line system. FUEL PUMP FUEL FILTER FUEL PUMP BRACKET FUEL PUMP CROSS SECTION (Side view) PUMP ASSEMBLY CROSS SECTION (Top view) DISCHARGE PORT INLET PORT RELIEF VALVE […]
Roof Lock Receivers Adjustment NOTE: This adjustment should be done in the following order after removing or replacing the lock receiver. 1. Loosen the lock receiver mounting bolts at each of the four corners, then tighten them lightly. 2. Install the roof on the body. CAUTION: When installing the roof, make sure both roof side […]
(G551) ’95-’96 Models. (G401,G402,G551) ’93-94 Models or Brake Switch Test 1. If one of the brake lights does not go on, check that brake light bulb in the taillight or the high mount light 2. If none of the brake lights 90 on, check the No. 45 (20 A) fuse in the under-hood fuse/relay box. […]