Lock Receivers Adjustment
NOTE: This adjustment should be done in the following
order after removing or replacing the lock receiver.
1. Loosen the lock receiver mounting bolts at each of
the four corners, then tighten them lightly.
2. Install the roof on the body.
CAUTION: When installing the roof, make sure
both roof side locks are unlocked.
NOTE:
• Make sure each roof side hook aligns with the
hook stop properly.
• Before securing the roof by turning each roof
side lock handle, check that the roof side retainer
aligns against the front pillar retainer and rear
pillar panel evenly at each side, and check that
the seals fit flush.
ROOF
ROOF SIDE
HOOK
HOOK STOP
Front:
FRONT PILLAR
RETAINER
ROOF
ROOF SIDE
SEAL
FRONT PILLAR
SEAL
Rear:
ROOF SIDE
RETAINER
ROOF SIDE
RETAINER
REAR PILLAR
PANEL
ROOF SIDE
SEAL
NOTE: The seals should fit flush.
REAR PILLAR
SEAL
3. Secure the roof by turning both roof side lock han-
dles. Make sure they are locked securely.
NOTE: Turn each roof side lock handle until a faint
click is heard.
ROOF SIDE
LOCK HANDLE
REAR LOCK
RECEIVER
FRONT LOCK
RECEIVER
4. Tighten the lock receiver mounting bolts at each of
the four corners.
5. Check that the seals fit flush.
6. Check the height of the roof with the body. If neces-
sary, loosen the lock receiver mounting bolts, then
adjust the height of the roof to make the roof fit
flush with the body by using shims.
FRONT LOCK
RECEIVER
Front:
ROOF
Roof
Lock Receivers Adjustment
Rear: REAR LOCK
RECEIVER
7. Tighten the lock receiver mounting bolts.
8. Check that each roof side lock handle works smoothly.
9. Remove the roof.
10. Reinstall all remaining removed parts.