Intake Manifold/Exhaust System ’91−’94 Models Intake Manifold Replacement 9−2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . […]
Categories
nsx09index.pdf
Month: August 2017
Categories
nsxb23190a.pdf
Lighting System Retractor Relay Test 1. Remove the retractor relay (located at the right side of the front compartment area). 2. Check continuity at the relay terminals. • There should be continuity between the E and F terminals and between the B and C terminals. • There should be continuity between the A and C […]
A/C Triple Pressure Switch Construction The A/C triple pressure switch consists of a High-Low pressure switch (A/C pressure switch A) and a Middle pressure switch (A/C pressure switch B). • High-Low pressure switch If the refrigerant pressure becomes too high (due to blockage), or too low (due to leakage), the A/C triple pressure switch sends […]
Categories
nsxb23272a.pdf
Power Windows Control Unit Input Test NOTE: The control unit only controls the driver’s door window. Remove the driver’s door panel and disconnect the 4-P and 6-P connectors from the control unit. Inspect the connector and socket terminals to be sure they are all making good contact. • If the terminals are bent, loose, or […]
Categories
nsxb18028a.pdf
Front Damper Inspection SELF-LOCKING NUT 10 x 1.25 mm Replace. 30 N-m (3.0 kg-m. 22 Ib-ft) DAMPER MOUNTING RUBBER SELF-LOCKING NUT 10 x 1.25 mm Replace. 44 N-m (4.4 kg-m, 32 Ib-ft) DAMPER MOUNTING BASE DAMPER MOUNTING WASHER Check for weakness. DAMPER MOUNTING COLLAR DAMPER MOUNTING RUBBER DUST COVER PLATE DUST COVER END DUST COVER […]
Categories
nsxd11126a.pdf
Fuel Supply System Replacement Fuel Tank Do not smoke while working on fuel system. Keep open flame away from your work area. Make sure lifts are placed properly (see page 1-9). 1. Raise the car. 2. Remove the drain bolt and drain the fuel into an approved container. 3. Remove the center rod (see section […]
Categories
nsxb11007a.pdf
System Description Vacuum Connections CONTROL BOX page 11-8 EVAP PURGE FLOW SWITCH INTAKE AIR BYPASS (IAB) DIAPHRAGM FUEL PRESSURE REGULATOR EVAP PURGE CONTROL DIAPHRAGM VALVE EVAP CONTROL CANISTER FRONT OF VEHICLE EGR VALVE LIFT SENSOR To EVAP TWO-WAY VALVE EGR VALVE System Description Vacuum Connections (cont’d) Control Box EVAPORATIVE EMISSION (EVAP) PURGE CONTROL SOLENOID VALVE […]
Categories
nsxe19065a.pdf
Solenoid Flushing 1. Remove the motor relay from the under-hood fuse/relay box. (Location: page 19 – 40) 2. Install the auxiliary window switch (07KAZ — 001000A) into the two motor relay cavities in the relay box. MOTOR RELAYWINDOW SWITCH 07KAZ-001000A UNDER-HOOD FUSE/RELAY BOX 3. Disconnect the four modulator solenoid connec- tors. 4. Bleed any high-pressure […]
Categories
nsxe20045a.pdf
Replacement SRS wire harnesses are routed near the dashboard and steering column, CAUTION: AH SRS electrical wiring harnesses are covered with yellow outer insulation. Before disconnecting the SRS wire harness, in- stall the short connector on the airbag (see page 23-232). Replace the entire effected SRS harness assembly If it has an open circuit or […]
Categories
nsxb19040a.pdf
Wiring/Connector Location Mam Menu Table of Contents Wiring/Connector Location ,— FRONT FAIL-SAFE RELAY REAR FAIL-SAFE RELAY INSPECTION CONNECTOR SERVICE CHECK CONNECTOR RIGHT-FRONT SENSOR CONNECTOR ABS PARKING BRAKE SWITCH CONNECTOR LEFT—FRONT SENSOR CONNECTOR PRESSURE SWITCH CONNECTOR RIGHT-FRONT SOLENOID CONNECTOR LEFT-FRONT SOLENOID CONNECTOR RIGHT-REAR SOLENOID CONNECTOR LEFTvREAR SOLENOID CONNECTOR PUMP MOTOR CONNECTOR RIGHT-REAR SENSOR CONNECTOR LEFT-REAR SENSOR […]