Timing Belt Installation Install the timing belt in the reverse order of removal; Only key points are described here. NOTE: Clean the middle and lower covers before instal- lation. 1. Set the timing belt drive pulley so that the No. 1 pis- ton is at top dead center (TDC). Align the mark on the teeth […]
Description Clutches The four speed automatic transmission uses hydraulically actuated clutches to engage or disengage the transmission gears. When clutch pressure is introduced into the clutch drum, the clutch piston is applied. This presses the friction discs and steel plates together, locking them so they don’t slip. Power is then transmitted through the engaged clutch […]
Security Alarm System Control Unit Input Test Remove the glove box and disconnect the 22-P connec- tor and 16-P connector from the control unit. Inspect the connector terminals to be sure they are all making good contact. If the terminals are bent, loose, or corroded, repair them as necessary, and recheck the system. If the […]
There should be continuity between the A and B termi- nals when the battery is connected to the C and D ter- minals. There should be no continuity between the A and B ter- minals when the battery is disconnected. Fail-Safe Relay Test Electronic Components TCS Switch Test There should be continuity between the D […]
Transmission Housing Bearings Replacement 2. Expand each snap ring with the snap ring pliers, insert the new bearing part-way into it, then release the pli- ers. Push the bearing down into the transmission until the ring snaps in place around it. 1. To remove the mainshaft, countershaft and secondary shaft bearings from the transmission housing, […]
Disassembly 1. Remove the ball bearing using a bearing puller as shown. Clutch housing side: Transmission housing side: BEARING PULLER (Commercially available) BALL BEARING BEARING SEPARATOR, 0-4 1/2 in. (Commercially available) BEARING PULLER (Commercially available) BALL BEARING BEARING SEPARATOR, 0-4 1/2 in. (Commercially available) Mainshaft Assembly Disassembly CAUTION: Remove the synchro hubs using a press […]
SET/RESUME Switch Test CAUTION: Before disconnecting any part of an SRS wire harness, connect the short connectors (see section 24). 1. Disconnect the cable reel harness and main harness 6-P connector. Connect test harness C only to the cable reel harness side of the 6-P connector. CABLE REEL HARNESS 6-P CONNECTOR TEST HARNESS C 07LAZ […]
Power Door Locks Control Unit Input Test Remove the glove box, then disconnect the 18-P con- nector from the control unit. Inspect the connector terminals to be sure they are all making good contact. • If the terminals are bent, loose, or corroded, repair them as necessary, and recheck the system. • If the terminals […]
Ceiling/Courtesy/Trunk Lights Courtesy Light Test/Replacement NOTE: The bulb or lens alone can be replaced without having to remove the door panel. 1. Remove the door panel (see section 20). 2. Remove the two screws and the retainer plate, then remove the light from behind the door panel. 3. Make sure that the bulb is OK, […]
Timing Belt Inspection 1. Remove the ignition coil covers and harness clamps. 2. Disconnect the connectors, then remove the ignition coils. 3. Remove the cylinder head covers, 4. Inspect the timing belt for cracks and coolant or oil soaking. NOTE: Replace the belt if coolant or oil soaked. Remove any oil or solvent that gets […]