Categories
Electrical

nsxb23204a.pdf

Ceiling/Courtesy/Trunk Lights
Courtesy Light Test/Replacement
NOTE: The bulb or lens alone can be replaced without
having to remove the door panel.
1. Remove the door panel (see section 20).
2. Remove the two screws and the retainer plate, then
remove the light from behind the door panel.
3. Make sure that the bulb is OK, then check for con-
tinuity between the A and B terminals. There should
be continuity.
NOTE: This light has a built-in diode. To get an ac-
curate reading, either test it with a volt-ohmmeter
that compensates for diodes, or make sure you con-
nect your test leads to match the polarity shown.
DOOR PANEL
RETAINER
PLATE
BULB (3.4 W)
LENS
From No.34 (15A) FUSE
To DOOR SWITCH
Door Switch Test
1. Remove the door panel (see section 20).
2. Disconnect the 2-P connector from the door switch.
View from
terminal side
2-P CONNECTOR
DOOR SWITCH (Built into door lock actuator assembly)
3. Check for continuity at the connector terminals.
• There should be continuity with the switch
released (door open).
• There should be no continuity with the switch
pushed (door closed).
HOUSING

Attachments