System Description Suspension Composition Outline Double wishbone independent suspension has been selected for each of the four wheels. This eliminates damper friction along the steering axis, and permits suspension geometry that takes full advantage of the performance potential of the wide, low aspect ratio tires. The double wishbone design also allows the use of aerodynamically-efficient […]
Controller Removal SRS components are located in this area. Review the SRS component locations, precautions, and procedures in the SRS section 24 before performing repairs or service. 1. Remove the dashboard lower cover, and disconnect the connectors. 2. Remove the dashboard lower pad. DASHBOARD LOWER COVER 3. Remove the tilt cover. DASHBOARD LOWER PAD TILT […]
Wipers/Washers Windshield Wiper Motor Replacement 1. Open the hood and remove the cap nuts and the wiper arms. NOTE: Carefully remove the wiper arms so that they do not touch the hood. 2. Remove the windshield lower molding, hood seal and air scoop by prying off the trim clips and removing the screws (see page […]
Gearshift Mechanism Overhaul NOTE: • Inspect rubber parts for wear and damage when disassembling. • Check that the new cotter pin is seated firmly. SELECT LINK COLLAR SHIFT LEVER 6 x 1.0 mm BOLTS 10 N-m (1.0 kg-m, 7 Ib-ft) 6 x 1.0 mm 10 N-m (1.0 kg-m, 7 Ib-ft) COTTER PIN Replace. 6 x […]
Security Alarm System Control Unit Input Test Remove the glove box to disconnect the 22-P connec- tor and 16-P connector from the control unit. Make the following input tests at the harness pins. NOTE: Recheck the connections between the 22-P con- nector and the control unit, the 16-P connector and the control unit, then replace […]
Headlights Description The light first forms basic pattern A after being interrupt- ed by the interrupter plate and passed through the con- vex lens. The interrupter plate determines the form. The outer lens distributes the light into pattern B. Screen CONVEX LENS INTERRUPTER PLATE BULB REFLECTOR OUTER LENS Attachments nsxb23191a (47 kB)
Wipers/Washers High Relay/Washer Relay Test 1. Remove the wiper high relay or the washer relay from under-hood relay box B. 2. Check continuity at the relay terminals. • There should be continuity between the C and D terminals. • There should be continuity between the A and B terminals when power and ground are connect- […]
Rear Brake Disc Run-Out Inspection 1. Raise each side of the car, and support it on safety stands (see page 1-6 through 1-8). Remove the rear wheels. 2. Remove the brake pads (see page 19-17). 3. Inspect the disc surface for grooves, cracks, and rust. Clean the disc thoroughly and remove all rust. 4. Use […]
Replacement SRS components are located in this area. Review the SRS component locations, precautions, and procedures in the SRS section 24 before performing repairs or ser- vice. 1. Remove the clock (see page 23-231). 2. Remove the two screws behind the clock, then remove the center air vent (see section 20). 3. Remove the four […]
R-Replace I—Inspect After inspection, clean, adjust, repair or replace if necessary. SEC and PAGE 11-129 11-102 11-151 6-54 11-114 11-4 23-96 8-4 8-5 23-109 10-2 10-5 6-21 10-10 11-144 9-4 9-4 13-3 14-90 For cars sold in California, this service is recommended only: other areas, it is required. Replace every 6 years or 60,000 miles […]