Alternator (ALT) FR Signal This signals the ECM when the Alternator (ALT) is charging. Inspection of ALT FR Signal. ECM CONNECTORS WIRE SIDE OF FEMALE TERMINALS Check for a short in the wire: 1. Turn the ignition switch OFF. 2. Disconnect the negative bat- tery cable from the battery. 3. Disconnect the ECM connec- tor […]
Road Test NOTE: Warm up the engine to normal operating temperature (the cooling fan comes on). When the engine coolant temperature is below normal operating temperature, the shift point is higher than specified vehicle speed. Range 1. Apply parking brake and block the wheels. Start the engine, then move the selector to while depressing the […]
Engine Oil Inspection 1. Check engine oil with the engine off and the car parked on level ground. 2. Make certain that the oil level indicated on the dipstick is between the upper and lower marks. 3. If the level has dropped close to the lower mark, add oil until it reaches the upper mark. […]
Idle Control System NOTE: Across each row in the chart, the sub systems that could be sources of a symptom are ranked in the order they should be inspected, starting with . Find the symptom in the left column, read across to the most likely source, then refer to the page listed at the top […]
Starter Solenoid Test 1. Check the hold-in coil for continuity between the S terminal and the armature housing (ground). The coil is OK if there is continuity. ARMATURE HOUSING (GROUND) PULL – IN COIL HOLD – IN COIL 2. Check the pull-in coil for continuity between the S and M terminals. The coil is OK […]
Specifications Standards and Service Limits Cylinder Head/Valve Train ’91−’95 Models 3−2. . . . . . . . . . . . . . . . . . . . . . ’96 Model 3−2. . . . . . . . . . . . . . . . . . . . . […]
Wipers/Washers Component Location Index SRS components are located in this area. Review the SRS component locations, precautions, and procedures in the SRS section (24) before performing repairs or ser- vice. UNDER-HOOD RELAY BOX B WIPER INTERMITTENT RELAY Test, page 23-291 (’94-’96) (’93) (’91-’92) WIPER LOW/HIGH RELAY Test, page 23-292 (’94-’96) (’93) (’91-’92) WASHER RELAY Test, […]
Exhaust Pipe and Muffler Replacement NOTE: Use new gaskets and self-locking nuts when reassembling. GASKETS Replace. JOINT PIPE REAR SECONDARY HO2S 45 N-m (4.5 kg-m, 33 Ib-ft) • Be careful not to damage. • Use the special tool for removal and installation. SELF-LOCKING NUTS 10 x 1.25 mm 34 N-m (3.4 kg-m, 25 Ib-ft) Replace. […]
Lubrication Points For the details of lubrication points and types of lubricants to be applied, refer to the Illustrated Index and various work procedures (such as Assembly/Reassembly, Replacement, Overhaul, Installation, etc.) contained in each section. No. LUBRICATION POINTS LUBRICANT Engine Transmission Manual Automatic Brake Line (including anti-lock brake system) Clutch Line Shift lever pivots (M/T) […]
Linear Solenoid Test 1. Remove the linear solenoid connector. 2. Measure the resistance between the A and B terminal. LINEAR SOLENOID View from terminal side 3. Replace the linear solenoid if resistance is out of specification. 4. Connect the B terminal of the linear solenoid con- nector to the battery positive terminal and the A […]