Categories
Cylinder Head & Valve Train

nsxd06036a.pdf

Rocker Arms and Lost Motion Assemblies Inspection NOTE: When reassembling the primary rocker arm, care- fully apply air pressure to the oil passage of the rocker arm. PRIMARY ROCKER ARM MID ROCKER ARM SECONDARY ROCKER ARM PISTONS 1. Inspect the rocker arm pistons. Push them manually. PRIMARY MID SECONDARY Apply oil to the pistons when […]

Categories
Electrical

nsxe23148a.pdf

Shift Lever Position Indicator CAUTION: All SRS electrical wiring harnesses are covered with yellow outer insulation. Before disconnecting the SRS wire harness, install the short connector on the airbag (see page STET) Replace the entire affected SRS harness assembly if it has an open circuit or damaged wiring. After installation of the gauge assembly, recheck […]

Categories
Uncategorized

nsxsrswarn.pdf

SUPPLEMENTAL RESTRAINT SYSTEM (SRS) The Acura NSX & NSX-T SRS includes a driver’s airbag located in the steering wheel hub and a passenger’s airbag located in the dashboard above the glove box, and seat belt tensioners, located in the seat belt retractors. Information necessary to safely service the SRS is included in this Service Manual. […]

Categories
Heating, Ventilation and Air Conditioning

nsxb22088a.pdf

Belt Adjustment Deflection Method 1. Apply a force of 100 N (10 kg, 22 Ib) and measure the deflection between the A/C compressor and the crankshaft pulley. A/C Compressor Belt Used Belt: 10-12 mm (0.39-0.47 in) New Belt: 5.5-7.5 mm (0.22-0.30 in) NOTE: • If there are cracks or any damage evident on the belt, […]

Categories
Electrical

nsxe23068a.pdf

Under-Dash Fuse Box Removal/Installation CAUTION; Be sure to install the SRS wiring so that it is not pinched or interfering with other car parts. Always keep the short connector on the airbag con- nector when the harness is disconnected. Removal: 1. Disconnect both the negative cable and positive ca- ble from the battery. 2. Remove […]

Categories
Fuel & Emissions

nsxd11134a.pdf

Intake Air System Description The throttle valve dashpot is employed to slow the closing of the throttle valve during gear shifting or deceleration. THROTTLE VALVE DASHPOT CONTROL DIAPHRAGM THROTTLE VALVE DASHPOT CHECK VALVE Throttle Valve Dashpot System Attachments nsxd11134a (163 kB)

Categories
Electrical

nsxb23012a.pdf

Relay and Control Unit Locations Engine Compartment REAR WINDOW DEFOGGER RELAY ENGINE COMPARTMENTFAN RELAY (A/T) Wire colors: YEL/BLK, BLU/RED, WHT/GRN, and WHT/BLU SPARK PLUG VOLTAGE DETECTION MODULE ENGINE COMPARTMENT FUSE/RELAY BOX IGNITION CONTROL MODULE (ICM) Attachments nsxb23012a (62 kB)

Categories
Electrical

nsxb23240a.pdf

Stereo Sound System Unit Terminals For MAST ANTENNA DIN CONNECTOR (for CD CHANGER) For WINDOW ANTENNA Terminal Wire Connects to Power Amplifier Relay Test 1. Remove the power amplifier relay from under-hood relay box 8. 2. Check continuity at the relay terminals. • There should be continuity between the C and D terminals. • There […]

Categories
Brakes & ABS

nsxb19002a.pdf

Special Tools Ref. No. Tool Number 07HAA – SG00100 or 07HAA – SG00101 07HAE – SG00100 07HAJ – SG00100or 07HAJ – SG0010B 07JAG – SD40100 07KA2 – 001000A 07914 – SA50000 Description Bleeder T-Wrench Brake Spring Compressor ALB Checker (US) Pushrod Adjustment Gauge Auxiliary Window Switch Snap Ring Pliers Qty 1 1 1 1 1 […]

Categories
Electrical

nsxd23212a.pdf

Side Marker/Turn Signal/Hazard Flash System Turn Signal/Hazard Relay Input Test 1. Remove the dashboard lower cover. Remove the turn signal/hazard relay from the left kick panel, then dis- connect the 6-P connector. 2. Inspect the connector terminals to be sure they are all making good contact. If the terminals are bent, loose or corroded, repair […]