Water Leak Test NOTE: When the following parts have been replaced or removed, and or the roof side lock unit, door glass and door have been adjusted, this water leak test should be done. • Roof side seals • Roof side lock units • Front and rear pillar seals • Door and door glass 1. […]
Ignition Control Module (ICM) Input Test Disconnect the 8-P connector from the ignition control module (ICM). Inspect the connector and socket terminals to be sure they are all making good contact. • If the terminals are bent, loose, or corroded, repair them as necessary, and recheck the system. • If the terminals look OK, make […]
Brake Warning System Parking Brake Switch Test 1. Remove the center console, and disconnect the con- nector from the switch. 2. Check continuity between the positive terminal and body ground with the brake lever up and down. • There should be no continuity with the brake lever down. • There should be continuity with the […]
Synchro Ring, Gear Inspection 1. Inspect the synchro ring and gear. A : Inspect the inside of the synchro ring for wear. B : Inspect the synchro sleeve teeth and matching teeth on the synchro ring for wear (rounded off). C : Inspect the synchro sleeve teeth and matching teeth on the gear for wear […]
Idle Control System System Troubleshooting Guide NOTE: Across each row in the chart, the sub-systems that could be sources of a symptom are ranked in the order they should be inspected, starting with . Find the symptom in the left column, read across to the most likely source, then refer to the page listed at […]
Shift Lever Position Indicator CAUTION: All SRS electrical wiring harnesses are covered with yellow outer insulation. Before disconnecting the SRS wire harness, Install the short connector on the airbus (see page 23-323). Raplace the entire affected SRS harness assembly if it has an open circuit or damaged wiring. After installation of the gauge assembly, recheck […]
Manual Steering Gearbox Removal/Installation NOTE: Before removing the steering gearbox, make sure the front wheels are straight ahead. 1. Remove the steering joint cover. STEERING JOINT COVER CLAMPCLIP 2. Remove the steering joint bolts, and disconnect the steering joint by moving the joint toward the column. STEERING JOINT STEERING JOINT BOLTS 22 N.m (2.2 kg-m, […]
Intake Air System Intake Air Bypass (IAB) Control System (cont’d) Disassembly 22 N.m (2.2 kg-m, 16 Ib-ft) INTAKE MANIFOLD 22 N.m (2.2 kg-m. 16 Ib-ft) GASKET Replace. WASHER Replace. 22 N.m (2.2 kg-m, 16 Ib-ft) GASKET Replace. CHAMBER ICM IAB VALVE BODY ASSEMBLY GASKET Replace Attachments nsxd11140a (194 kB)
Mainshaft Assembly Inspection 1. Inspect the gear surface and bearing surface for wear and damage, then measure the mainshaft at points A, B, and C. Standard: A (Ball bearing surface): 32.002—32.018 mm (1.2599-1.2605 in) B (Needle bearing surface): 42.984—43.000 mm (1.6923-1.6929 in) C (Ball bearing surface): 30.984-31.000 mm (1.2198-1.2205 in) Service limit: A: 31.950 mm […]
Electronic Control System Electronic Control System The electronic control system consists of the Transmission Control module (TCM), sensors, a linear solenoid and 4 solenoid valves. Shifting and lock-up are electronically controlled for comfortable driving under and conditions. The TCM is located on the insulator center bulkhead, behind the driver’s seat. Shift control Shifting is related […]