Side Marker/Turn Signal/Hazard Flash System Turn Signal/Hazard Relay Input Test Remove the dashboard lower cover. Remove the turn signal/hazard relay from the left kick panel then disconnect the 6-P connector. Make the following input tests at the 6-P connector ter- minals. If all tests prove OK, but the relay fails to work, replace the turn […]
Exhaust Gas Recirculation (EGR) System The EGR system is designed to reduce oxides of nitrogen emissions (NOx) by recirculating exhaust gas through the EGR valve and the intake manifold into the combustion chambers. It is composed of the EGR valve, EGR vacuum control valve, EGR control solenoid valve, ECM and various sensors. The ECM contains […]
Maintenance Transmission Oil NOTE: Check the oil at normal operating temperature (the cooling fan comes on), engine OFF, and the car on level ground. 1. Remove the oil filler plug, then check the level and condition of the oil. WASHER Replace. Proper Level OIL FILLER PLUG 45 N-m (4.5 kg-m. 33 Ib-ft) 2. The oil […]
View from the back of the gauge assembly. PRINTED CIRCUIT BOARD A BOARD-TO-BOARD CONNECTOR PRINTED CIRCUIT BOARD B NOTE: The number in the table show the troubleshooting sequence. Speedometer/Trip meter/Odometer Troubleshooting NOTE: A short to ground in the ORN wire can be caused by a short in any component connected to it. Vehicle Speed Sensor […]
Warning/Caution Label Locations SRS CAUTION LABELS: Refer to page 1-6 TIRE INFORMATION Mam Menu Table of Contents Warning/Caution Label Locations ∣− SRS CAUTION LABELS: Refer to page 1-6 FROZEN BATTERY CAUTION BATTERY CAUTION ABS CAUTION RADIATOR BLEED PLUG CAUTION ABS and BRAKE FLUID CAUTION AIR CONDITIONING R-134a CAUTION (U.S.A. only) RETRACTABLE HEADLIGHT CAUTION EXPANSION TANK […]
Switches The lighting system is controlled by five switches and the turn signal cancel unit. HEADLIGHT SWITCH TURN SIGNAL CANCEL UNIT HAZARD WARNING SWITCH TURN SIGNAL and DIMMER SWITCH TURN SIGNAL CANCEL SWITCH Attachments nsxb23177a (30 kB)
Headlights Adjustment Adjust the headlights to local requirements by turning the adjusters as shown. NOTE: Be careful not to damage the front fender or the headlight housing when adjusting. HEADLIGHT HORIZONTAL AIM ADJUSTER HEADLIGHT VERTICAL AIM ADJUSTER PROTECTIVE TAPE Attachments nsxb23192a (43 kB)
Charging System Component Location Index CHARGING SYSTEM LIGHT (Built into the gauge assembly) Test, page 23-100 BATTERY Test, page 23-68 ALTERNATOR BELT Adjustment, page 23-109 ALTERNATOR • Alternator and Regulator Test, page 23-102 • Replacement, page 23-105 • Overhaul, page 23-106 Attachments nsxb23098a (47 kB)
Washer Replacement 1. Disconnect the hose and the 2-P connectors from the washer motor. 2. Remove the bumper, then remove the washer reservoir by removing the three mounting bolts. 3. Remove the washer nozzles. 4. Install the washer nozzles, and take note of the fol- lowing: • Clip the hose to the front harness. • […]
Fast Idle Valve Description To prevent erratic running when the engine is warming up, it is necessary to raise the idle speed. The fast idle air bypass valve is controlled by a thermowax plunger. When the engine is cold, the engine coolant surroun- ding the thermowax contracts the plunger, allowing ad- ditional air to be […]