Categories
Electrical

nsxb23297a.pdf

Washer Replacement
1. Disconnect the hose and the 2-P connectors from
the washer motor.
2. Remove the bumper, then remove the washer
reservoir by removing the three mounting bolts.
3. Remove the washer nozzles.
4. Install the washer nozzles, and take note of the fol-
lowing:
• Clip the hose to the front harness.
• Take care not to pinch hoses during reinstalla-
tion.
• Install the clips firmly.
• After installation, adjust the washer nozzles.
Windshield Washer Motor Test
1. Disconnect the 2-P connector from the washer
motor and remove the front bumper.
2. Test the washer motor operation by connecting
power to the terminal and ground to the
terminal.
WASHER FLUID
RESERVOIR
WINDSHIELD
WASHER
MOTOR
• If the motor fails to run smoothly, replace it.
• If the motor runs smoothly but little or no washer
fluid is pumped, check for a disconnected or
blocked washer hose, or a clogged pump outlet
in the motor.

Attachments