Evaporative Emission (EVAP) Controls Description The evaporative emission controls are designed to minimize the amount of fuel vapor escaping to the atmosphere. The system consists of the following components: A. Evaporative Emission (EVAP) Control Canister An EVAP control canister is used for the temporary storage of fuel vapor until the fuel vapor can be purged […]
Pressure Plate, Clutch Disc, Mid Plate Installation NOTE: • Install the pressure plate, clutch discs, and mid plate as a set. • Do not mix-up the 1st and 2nd clutch discs. The 2nd clutch disc has a flat plate between the two friction surfaces. The 1st clutch disc has a spring plate be- tween the […]
Description The automatic transmission is a combination of a 3-element torque converter and a triple-shaft electronically controlled automatic transmission which provides 4 speeds forward and 1 in reverse. The entire unit is positioned in line with the engine. TORQUE CONVERTER, GEARS AND CLUTCHES The torque converter consists of a pump, turbine and stator, assembled in […]
Relay Test 1. Remove the power window relay in the under-hood fuse/relay box. 2. Check continuity at the relay terminals. • There should be continuity between the C and D terminals. • There should be continuity between the A and B terminals when power and ground are connect- ed to the C and D terminals. […]
Radiator Fan Motor Test 1. Disconnect the 2-P connector from the radiator fan motor. 2. Test the motor by connecting battery power to the A terminal, and ground to the B terminal. 3. If the motor fails to run or does not run smoothly, replace it. Condenser Fan Motor Test 1. Disconnect the 2-P connector […]
Dashboard, Door and Floor DRIVER’S DOOR PANEL ABS CONTROL UNIT DAYTIME RUNNING LIGHTS CONTROL UNIT (Canada) POWER WINDOW CONTROL UNIT STARTER CUT RELAY Wire colors: BLK/WHT, BLK/WHT, BLK/GRN, and BLK/BLU SECURITY CONTROL UNIT CIGARETTE LIGHTER RELAY Wire colors: YEL/RED, BLU/GRN, BRN/YEL, and BLK FOOT WELL BASS SPEAKER EPS CONTROL UNIT (Behind foot well bass speaker) […]
Intake Manifold Replacement NOTE: Use new O-rings and gaskets when reassembling. CAUTION: • Check for folds or scratches on the surface of the gasket. • Replace with a new gasket if damaged. 6 x 1.0 mm 12 N-m (1.2 kg-m, 9 Ib-ft) 5 x 1.0 mm 8 N-m (0.8 kg-m, 6 Ib-ft) INTAKE AIR TEMPERATURE […]
Illustrated Index CAUTION: Before disassembling the gearbox, wash it off with solvent and a brush. Thoroughly clean all disassembled parts. Replace parts with damaged sliding surfaces. SET SCREW LOCKNUT FLANGE BOLT PINION DUST SEAL Check for damage. STEERING GROMMET A Check for damage. STEERING GROMMET B Check for damage.PINION SET SCREW PINION BEARING Check for […]
Towing If the car needs to be towed, call a professional towing service. Never tow the car behind another car with just a rope or chain. It is very dangerous. There are three widely used methods of towing a car: Flat-bed Equipment—The operator loads the car on the back of a truck. This is the […]
Troubleshooting Precautions EPS Indicator Light Under normal conditions, the EPS indicator light in the gauge assembly comes on when the ignition switch is turned to the ON (II) position, then goes off after the engine is started. This indicates that the bulb and its circuits are operating cor- rectly. If there is any trouble in […]