System Description Steering Column The NSX has a tilt/telescopic steering column. The tilt/telescopic mechanism makes it possible to adjust the steering wheel in fore and aft, and up and down directions. Tilt Mechanism There is a joint on the upper steering shaft, and the portion of the column between the steering wheel and this joint […]
Manual Valve Detent Spring Parking Brake Stopper Replacement/Adjustment NOTE: Select the appropriate manual valve detent spring when below parts are replaced. Manual Valve Manual Valve Detent Spring Manual Valve Lever of Control Shaft 1. Install the main valve body, including the oil pump gears, onto the torque converter housing and tight- en to 12 N.m […]
A/C System Service Evacuation Only use service equipment that is U.L.-listed and is cer- tified to meet the requirements of SAE J2210 to remove HFC-134a (R-134a) from the air conditioning system. CAUTION: Exposure to air conditioner refrigerant and lubricant vapor or mist can irritate eyes, nose and throat. Avoid breathing the air conditioner refrigerant and […]
Reassembly CAUTION: • Before reassembling, check that all parts are free of dust and other foreign particles. • Replace parts with new ones whenever specified to do so. • Use only clean DOT3 or 4 brake fluid. • Make sure no dirt or other foreign matter is allowed to contaminate the brake fluid. • Do […]
Rear Brake Pads Inspection/Replacement • Never use an air hose or dry brush to clean brake assemblies, Use an OSHA-approved vacuum cleaner to avoid breathing brake dust. 1. Loosen the rear wheel nuts slightly, then raise each side of the car and support it on safety stands (see page 1-9 through 1-11). Remove the rear […]
Identification Number Locations VEHICLE IDENTIFICATION NUMBER MANUAL TRANSMISSION NUMBER VEHICLE IDENTIFICATION NUMBER AUTOMATIC TRANSMISSION NUMBER ENGINE NUMBER Attachments nsxb01004a (67 kB)
Parking Brake Disassembly and Reassembly CAUTION: The parking brake cables must not be bent or distorted. This will lead to stiff operation and permature cable failure. Attachments nsxb19027a (41 kB)
Charging System Rotor Slip Ring Test 1. Check that there is continuity between the slip rings. 2. Check that there is no continuity between the slip rings and the rotor or rotor shaft. ROTOR SHAFT SLIP RINGS ROTOR 3. If the rotor fails either continuity check, replace the alternator. Stator Test 1. Check that there […]
Stall Speed Test CAUTION: To prevent transmission damage, do not test stall speed for more than 10 seconds at a time. Do not shift the lever while raising the engine speed. Be sure to remove the pressure gauge before testing stall speed. 1. Engage the parking brake and block all four wheels. 2. Connect the […]
Mode Control Motor Test 1. Disconnect the mode control motor connector, turn the ignition switch ON (II), and move the blower switch to the middle setting. 2. Connect battery power to the No. 1 terminal of the mode control motor, then connect ground to the No. 2 terminal. The mode control motor should run, and […]