nsxb23294a.pdf

Wipers/Washers
Windshield Wiper Motor
Replacement
1. Open the hood, and remove the cap nuts and the
wiper arms. Don’t let the wiper arms hit the hood.
2. Remove the windshield lower molding, hood seal
and air scoop by prying off the trim clips and
removing the screws (see page 23-293 (’94-’96) (’93)
(’91-’92).
3. Disconnect the 5-P connector from the wiper motor
assembly, then remove the two mounting bolts and
the wiper linkage assembly.
WIPER LINKAGE ASSEMBLY
5-P CONNECTOR
4. Remove the three mounting bolts and nut from the
wiper linkage assembly, and remove the wiper
motor.
MOUNTING
BOLTS
8 N·m (0.8 kg-m,
5.8 Ib-ft)
NUT
18 N·m (1,8 kg-m, 13 Ib-ft)
WIPER LINKAGE
ASSEMBLY
WIPER MOTOR
5. Install the wiper motor assembly in the reverse
order of removal.
DASHBOARD LOWER
PAD
DASHBOARD LOWER
COVER
Windshield Wiper/Washer Switch
Replacement
SRS components are located in this area. Review the
SRS component locations, precautions, and procedures
in the SRS section (24) before performing repairs or ser-
vice.
1. Remove the dashboard lower cover, and disconnect
the connectors.
2. Remove the dashboard lower pad.