Engine Cover/Roof Cover
Removal
NOTE:
• Take care not to scratch the body.
• Open the rear hatch.
1. Open the engine cover, and support it with the sup-
port rod. Disconnect the roof holder switch connec-
tor, remove the nut, then remove the ground wire.
NOTE: If necessary, remove the roof switch sub-
harness.
ENGINE COVER
CONNECTOR
CONNECTOR GROUND
WIRE
ROOF HOLDER SWITCH
SUB-HARNESS
2. Remove the support rod from the engine cover.
Remove the bolts, than remove the engine cover.
ENGINE COVER
ENGINE COVER
EDGE CUSHIONS
ENGINE COVER
HINGE
BOLTS
6 x 1.0 mm
10 N-m (1.0 kg-m,
7.2 Ib-ft)
CORROSION RESISTANT BOLT
3. Installation is the reverse of the removal procedure.
NOTE:
• Make sure the roof holder switch connector is
connected properly.
• If necessary, turn the engine cover edge cush-
ions to make the engine cover fit flush with the
body.
SUPPORT
ROD
ENGINE COVER
EDGE CUSHIONS
GROMMET
ROOF HOLDER
SWITCH
HARNESS
CLIP
NUT
Removal
NOTE:
• Take care not to scratch the body.
• Open the rear hatch.
1. Open the engine cover, and support it with the sup-
port rod. Disconnect the roof holder switch connec-
tor, remove the nut, then remove the ground wire.
NOTE: If necessary, remove the roof switch sub-
harness.
ENGINE COVER
CONNECTOR
CONNECTOR GROUND
WIRE
ROOF HOLDER SWITCH
SUB-HARNESS
2. Remove the support rod from the engine cover.
Remove the bolts, than remove the engine cover.
ENGINE COVER
ENGINE COVER
EDGE CUSHIONS
ENGINE COVER
HINGE
BOLTS
6 x 1.0 mm
10 N-m (1.0 kg-m,
7.2 Ib-ft)
CORROSION RESISTANT BOLT
3. Installation is the reverse of the removal procedure.
NOTE:
• Make sure the roof holder switch connector is
connected properly.
• If necessary, turn the engine cover edge cush-
ions to make the engine cover fit flush with the
body.
SUPPORT
ROD
ENGINE COVER
EDGE CUSHIONS
GROMMET
ROOF HOLDER
SWITCH
HARNESS
CLIP
NUT