Category: Automatic Transmission

Manual Valve Detent Spring Parking Brake Stopper Replacement/Adjustment NOTE: Select the appropriate manual valve detent spring when below parts are replaced. Manual Valve Manual Valve Detent Spring Manual Valve Lever of Control Shaft 1. Install the main valve body, including the oil pump gears, onto the torque converter housing and tight- en to 12 N.m […]

Stall Speed Test CAUTION: To prevent transmission damage, do not test stall speed for more than 10 seconds at a time. Do not shift the lever while raising the engine speed. Be sure to remove the pressure gauge before testing stall speed. 1. Engage the parking brake and block all four wheels. 2. Connect the […]

(cont’d) Do not set here.Set here. CAUTION: If either end of the compressor attach- ment is set over an area of the spring retainer which is unsupported by the return spring, the retainer may be damaged. CLUTCH SPRING COMPRESSOR BOLT ASSEMBLY 07GAE-PG4O200 DISC SPRING 2. Remove the disc spring. NOTE: For 1 st-hold and 2nd […]

Illustrated Index Left Side Cover Main Menu Table of Contents Illustrated Index Left Side Cover 14-100 LEFT SIDE COVER DOWEL PIN GASKET Replace. SEALING WASHER Replace. O-RING Replace. 1ST-HOLD CLUTCH FEED PIPE O-RING Replace. FEED PIPE FLANGE SNAP RING 1ST CLUTCH FEED PIPE O-RING Replace. FEED PIPE FLANGE SNAP RING CONICAL SPRING WASHER Replace. BALL […]

Symptom-to-Component Chart Electrical System Number of indicator light blinks while Service Check Connector is jumped. When the ignition switch is turned on, indicator light 1 Blinks Possible Cause Symptom Lock-up clutch does not engage. Lock-up clutch does not disengage. Unstable idle speed. Refer to page 14-54 14-55 14-56 14-57 14-58 14-60 14-62 14-63 14-64 14-66Lock-up […]

SCREWDRIVER ONE-WAY CLUTCH 3. After the parts are assembled, hold countershaft 1 st gear and turn the parking gear in the direction shown to be sure it turns freely. COUNTERSHAFT 1ST GEAR Inspect for wear or scoring. ONE-WAY CLUTCH Inspect for damage or faulty movement. NEEDLE ROLLER BEARINGS Inspect for galling and rough movement. 1ST […]

Transmission Installation 1. Place the transmission on the transmission jack, and raise to the engine level. 2. Check that the 14 mm and 10 mm dowel pins are installed in the torque converter housing. 3. Install the 3 transmission housing mounting bolts. 4. Install the 3 rear transmission mounting bolts. 5. Loosen the front engine […]

CAP SPRING VALVE VALVE BODY ROLLER CAP VALVE BODY SPRING SEAT ROLLER SPRING VALVE VALVE BODY Valve Assembly NOTE: Coat all parts with ATF before assembly. Set the spring in the valve and install it in the valve body. Push the spring in with a screwdriver then in- stall the spring seat. SPRING Install the […]

ATF Cooler The radiator is mounted at the front of the vehicle. The ATF cooler is installed directly on the transmission housing. The ATF is cooled by the engine coolant. OUTLET HOSE INLET HOSE Coolant ATF COOLER Attachments nsxd14045a (134 kB)

Gearshift Selector All SRS wiring harnesses are covered with yellow outer insulation. Before disconnecting any part of the SRS wire harness, install the short connectors (see page 23-328). Replace the entire affected SRS harness assembly if it has an open circuit or damaged wiring. CAUTION: SELECT LEVER KNOB 3 N.m (0.3 kg-m, 2 Ib-ft) SRS […]