nsxd14159a.pdf

Gearshift Selector
All SRS wiring harnesses are covered with yellow
outer insulation.
Before disconnecting any part of the SRS wire
harness, install the short connectors (see page
23-328).
Replace the entire affected SRS harness assembly if
it has an open circuit or damaged wiring.
CAUTION:
SELECT LEVER KNOB
3 N.m
(0.3 kg-m, 2 Ib-ft)
SRS MAIN
HARNESS
SILICONE GREASE
3 N.m
(0.3 kg-m, 2 Ib-ft)
Apply non hardening
thread lock sealant.
SHIFT INDICATOR PANEL
KEY CYLINDER
3 N.m
(0.3 kg-m, 2 Ib-ft)
5 N.m (0.5 kg-m, 4 Ib-ft)
A/T GEAR
POSITION
SWITCH
SILICONE
GREASE
LEVER COVER
SHIFT INDICATOR
3 N.m (0.3 kg-m, 2 Ib-ft)
SHIFT CABLE
SILICONE GREASE
10 N.m
(1.0 kg-m, 7 Ib-ft)
SHIFT LOCK
SOLENOID
E-CLIP
3 N.m
(0.3 kg-m, 2 Ib-ft)
DETENT COVER
DETENT PLATE10 N.m (1.0 kg-m, 7 Ib-ft)
BRACKET BEAM
SHIFT CABLE HOLDER
Install in this direction.
CONTROL
LEVER PIN
LOCK PIN
SELECTOR MOUNT
BRACKET
SILICONE
GREASE