Component Removal/Installation
SRS wire harnesses are routed near the dashboard.
CAUTION:
All SRS electrical wiring harnesses are covered with yellow outer insulation.
Before disconnecting the SRS wire harness, install the short connector on the airbag (see page 23-323).
Replace the entire effected SRS harness assembly if it has an open circuit or damaged wiring.
NOTE:
Take care not to scratch or score the dashboard.
Do not drop the screws inside the dashboard.
When prying with a flat tip screwdriver, wrap it with protective tape or shop
towel to prevent damage.
Disassemble in numbered
sequence.
CLOCK
CLOCK
CENTER AIR VENT
CENTER ARMREST
INNER PANEL
ASHTRAY
SRS UNIT
CENTER ARMREST
CENTER CONSOLE
PANEL
Lift up the parking
brake lever.
HEATER CONTROL UNIT
SRS UNIT
STEREO
CASSETE/RADIO
Disconnect the
connectors.
GLOVE BOX LID (cont’d)
DASHBOARD LOWER
PANEL (Passenger’s side)
GLOVE BOX
Disconnect the connectorsTRUNK LID OPENERMAIN SWITCH
PROTECTIVE
TAPE
CENTER AIR VENT
PROTECTIVE
TAPE
Dashboard
Component Removal/Installation (cont’d)
SRS wire harnesses are routed near the steering column.
CAUTION:
All SRS electrical wiring harnesses are covered with yellow outer insulation.
Before disconnecting the SRS wire harness, install the short connector on the airbag (see page 23-323).
Replace the entire effected SRS harness assembly if it has an open circuit or damaged wiring.
Driver’s Side:
NOTE:
Take care not to scratch or score the dashboard and steering column.
When prying with a flat tip screwdriver, wrap it with protective tape or shop towel to prevent damage.
Disassemble in numbered sequence.
L. DASH
SENSOR
R. DASH
SENSOR
CABLE REEL and
MAIN HARNESS SRS UNIT
RETRACTOR SWITCH/DASH
BRIGHTNESS CONTROLLER
INSTRUMENT
PANEL
TCS SWITCH
DASHBOARD
STAY
KNEE
BOLSTER
DASHBOARD LOWER
PANEL (Driver’s side)
KNEE BOLSTER
PAD
INSTRUMENT
PANEL
CLIP
KNEE BOLSTER
PADInstallation is the reverse of the removal procedure.