nsxd23302a.pdf

Cruise Control
A/T Gear Position Switch Test
1. Remove the front console, then disconnect the
12-P connector from the A/T gear position switch.
2. Check for continuity between the terminals in each
switch position according to the table.
Move the lever back and forth at each position
without touching the push button and check for
continuity within the range of free play of the
shift lever.
If there is no continuity within the range of free
play, adjust the position of the A/T gear position
switch (see page 23-160).
A/T GEAR POSITION SWITCH
12-P CONNECTOR
View from wire side.
A/T Gear Position Switch (For cruise control)
Actuator Assembly Test
1. Disconnect the 4-P connector from the actuator
assembly.
2. Check that the output linkage moves smoothly.
3. Connect battery power to the D terminal and
ground to the A terminal.
MOTOR
ACTUATOR
ASSEMBLY
OUTPUT
LINKAGE
4. Check for a clicking sound from the magnetic
clutch and that the output linkage is locked.
You should be able to hear the motor.
5. If the output linkage is not locked, replace the ac-
tuator assembly.
6. Check the operation of the actuator motor in each
output linkage position according to the table.
You should be able to hear the motor.
FULLY
OPEN
OUTPUT
LINKAGE
MIDDLE
POSITION
FULLY CLOSED