nsxb23244a.pdf

Stereo Sound System
Antenna Tube Replacement
1. Remove the antenna mast (see page 23-242).
2. Remove the power antenna motor (see page
23-242).
3. Remove the retaining screw, and pull the antenna
tube out of its socket in the drive housing.
ANTENNA
TUBE
RETAINING
SCREW
4. Remove the plastic guide and plastic insulator tube,
and install them in the new antenna tube.
ANTENNA
TUBE
PLASTIC
INSULATOR
TUBE
PLASTIC
GUIDE
5. Insert the new antenna tube.
With an alignment mark:
— Insert the new antenna tube in its socket, and
align the mark on the tube with the screw used
to retain it.
ALIGNMENT
MARK
RETAINING
SCREW
Without an alignment mark:
— Insert only the tube, and install the tube/motor
assembly in the car.
— Adjust the tube so that the collar fits properly
against the body, and mark the tube and motor.
— Remove the tube/motor assembly again.
— Align the mark on the tube with the mark on the
motor, and tighten the clamping screw.
Adjust the tube
so that the
collar fits the
contour of the
body.
When the alignment
is correct, mark the
tube and motor.
6. Install the power antenna motor (see page 23-242).
7. Insert the mast into the tube (see page 23-242).