Input Test
SRS components are located in this area. Review the
SRS component locations, precautions, and procedures
in the SRS section 24 before performing repairs or ser-
vice.
Remove the left kick panel cover, and the relay holder
from its bracket, then disconnect the 16-P connector
from the integrated control unit. Remove the integrated
control unit from the under-dash fuse box.
Inspect the connector and socket terminals to be sure
they are all making good contact.
• If the terminals are bent, loose, or corroded, repair
them as necessary, and recheck the system.
• If the terminals look OK, make the following input
tests at the connector.
— If any test indicates a problem, find and correct the
cause, then recheck the system.
— If all the input tests prove OK, the control unit
must be faulty; replace it.
NOTE: Different wires with the same color have
been given a number suffix to distinguish them (for
example, YEL1 and YEL2 are not the same). INTEGRATED
CONTROL UNIT
16-P CONNECTOR
UNDER-DASH FUSE BOX
These terminals are
not used.
View from wire side
View from wire side
Entry Light Timer System:
No. Terminal Test condition Test: Desired result Possible cause if result is not obtained
Key-in Reminder System:
No. Terminal Test condition Test: Desired result Possible cause if result is not obtained
Integrated Control Unit
Input Test
View from wire side
Lights-on Reminder System:
No. Terminal Test condition Test: Desired result Possible cause if result is not obtained
Seat Belt Reminder System:
No. Terminal Test condition Test: Desired result Possible cause if result is not obtained
Rear Window Defogger Timer System:
No. Terminal Test condition Test: Desired result Possible cause if result is not obtained
Oil Pressure Indicator System:
No. Terminal Test condition Test: Desired result Possible cause if result is not obtained
Integrated Control Unit
Input Test
Side Marker Light Flasher System:
No. Terminal Test condition Test: Desired result
View from wire side
Possible cause if result is not obtained
Power Window Key-off Timer System:
No. Terminal Test condition Test: Desired result Possible cause if result is not obtained
Combined Operation Wiper/Washer System:
No. Terminal Test condition Test: Desired result Possible cause if result is not obtained