Replacement
NOTE: Take care not to bend the cables.
Rear Hatch Opener/Latch:
REAR HATCH
OPENER CABLE
Disconnect the rear
hatch opener cable.
Replacement, see page 20-67
MOUNTING BOLTS
* 6 x 1.0 mm
10 N·m (1.0 kg-m,
7.2 Ib-ft) OPENER
HANDLE ROD
Coupe:
RETAINER
CLIP
NSX-T (open top):
RETAINER
CLIP
REAR HATCH
LATCH
LATCH SWITCH
Be careful not to damage
the latch switch. Discon-
nect the latch switch
connector.
LATCH SWITCH
CONNECTOR
MOUNTING BOLTS
*6 x 1.0 mm
10 N·m (1.0 kg-m, 7.2 lb-ft)
REAR HATCH
OPENER CABLE
Disconnect the rear hatch
opener cable.
RELEASE HANDLE
Pull out the retainer clip.
then remove the release
handle and rear aide trim
panel.
FUEL LID
After installing, check tor
a flush fit with the body.
REAR SIDE TRIM PANEL
Removal, see page 20-38
Fuel Lid Opener/Latch:
MOUNTING BOLTS
* 6 x 1.0 mm
10 N·m (1.0 kg-m,
7.2 Ib-ft)
FUEL LID
OPENER CABLE
MOUNTING BOLTS
*6 x 1.0 mm
13 N·m (1.3 kgm, 9 lb-ft)
FUEL LID LATCH
Lower the rear inner
fender and remove the
fuel lid latch by turning
it 90°.
FUEL LID LATCH
Push and turn the fuel lid
latch to make the fuel lid
fit flush with the body.
FUEL LID
FUEL LID
OPENER CABLE
Replacement, see page 20-67
OPENER
To remove the opener,
pull out the opener knob and
remove the side sill pad
and trim (see page 20-38
OPENER KNOB
Trunk Lid Opener/Latch:
NOTE: Take care not to bend the cable and rod.
TRUNK LID OPENER
ACTUATOR
MOUNTING BOLTS
6 x 1.0 mm
10 N-m (1.0 kg-m, 7.2 Ib-ft)
TRUNK KEY SWITCH
Be careful not to damage the
trunk key switch.
REAR PANEL
BOLT
LOCK ROD
OPENER CABLE
Installation is the reverse of the removal procedure.
NOTE: Make sure the opener cable is routed and
connected properly.
CORROSION RESISTANT BOLT/NUT
TRUNK LID
LATCH
REAR PANEL
CLIP
TRUNK LID LATCH
Remove the latch mounting
bolts and disconnect the lock
rod, opener cable, connector
and clip, then remove the trunk
lid latch from the hole in the
body panel.
CONNECTORS
LOCK CYLINDER
HARNESS
TRUNK LID
OPENER CABLE
REAR PANEL MOUNTING
NUTS
LATCH MOUNTING
BOLTS
6 x 1.0 mm
10 N-m (1.0 kg-m,
7.2 Ib-ft)
LOCK CYLINDER
MOUNTING BOLT
6 x 1.0 mm
10 N-m (1.0 kg-m,
7.2 Ib-ft)
TRUNK LID OPENER
CABLE Replacement,
see page 20-67
TRUNK LID OPENER
CABLE
LOCK CYLINDER
Disconnect the connector and
lock rod from the trunk lid latch.
Remove the rear panel and turn
the lock cylinder 45°.
Remove the lock cylinder from
the hole in the body panel.
LOCK
ROD