Categories
Body

nsxb20058a.pdf

Front Bumper
Replacement
1. Loosen the mounting screw, then pull the right and left front turn signal lights out and disconnect the connectors.
2. Remove the skirt covers, then remove the bumper mounting bolts on each side, and lower skirt mounting bolt.
3. Lower the inner fender, then remove the bumper mounting nuts and the skirt mounting bolts from inside the front
fender on each side.
4. Lift and remove the front bumper.
NOTE:
• Disconnect the washer hose, horn connecters, and ambient sensor connector.
• An assistant is helpful when removing the front bumper.
• Take care not to scratch the front bumper.
BUMPER BRACKET HOOK
INNER FENDER
FRONT TURN
SIGNAL LIGHT
5. Installation is the reverse of the removal procedure.
NOTE: Insert the bumper bracket hooks into the bumper bracket holes.
CONNECTORS
CORROSION RESISTANT BOLT/NUT
BUMPER MOUNTING BOLTS
8 x 1.25 mm 22 N-m
(2.2 kg-m, 16 Ib-ft)
AMBIENT
SENSOR
FRONT BUMPER
HORN
CONNECTORS
FRONT TURN
SIGNAL LIGHT
SKIRT COVER
LOWER SKIRT MOUNTING
BOLT
MOUNTING SCREW
SKIRT COVER
SKIRT MOUNTING BOLTS
6 x 1.0 mm
10 N-m (1.0 kg-m,
7.2 Ib-ft)
BUMPER MOUNTING NUTS
6 x 1.0 mm
10 N-m (1.0 kg-m,
7.2 Ib-ft)BUMPER BRACKET HOLE

Attachments