Power Unit
Torque/Inspection
CAUTION:
• Do not attempt to disassemble the power unit ex-
cept for those components shown in this illustration.
• Do not spill brake fluid on the car; it may damage the
paint; if brake fluid does contact the paint, wash it
off immediately with water.
• To prevent spills, cover the hose joints with rags or
shop towels.
• Clean all parts in brake fluid and air dry; blow out all
passages with compressed air.
Before reassembling, check that all parts are free of
dust and other foreign particles.
Replace parts with new ones whenever specified to
do so.
Make sure no dirt or other foreign matter is allowed
to contaminate the brake fluid.
Do not reuse the drained fluid.
Use only clean DOT 3 or 4 brake fluid.
BANJO BOLT
(To modulator)
35 N-m (3.5 kg-m, 25 Ib-ft)
SEALING
WASHERS
Replace
BANJO BOLT
35 N-m (3.5 kg-m, 25 Ib-ft)
MAINTENANCE
BLEEDER
9 N-m (0.9 kg-m, 6.5 Ib-ft)
POWER UNIT
Do not disassemble
PUMP BRACKET
6 mm FLANGE BOLT
10 N-m (1.0 kg-m, 7 Ib-ft)
Torque/Inspection
CAUTION:
• Do not attempt to disassemble the power unit ex-
cept for those components shown in this illustration.
• Do not spill brake fluid on the car; it may damage the
paint; if brake fluid does contact the paint, wash it
off immediately with water.
• To prevent spills, cover the hose joints with rags or
shop towels.
• Clean all parts in brake fluid and air dry; blow out all
passages with compressed air.
Before reassembling, check that all parts are free of
dust and other foreign particles.
Replace parts with new ones whenever specified to
do so.
Make sure no dirt or other foreign matter is allowed
to contaminate the brake fluid.
Do not reuse the drained fluid.
Use only clean DOT 3 or 4 brake fluid.
BANJO BOLT
(To modulator)
35 N-m (3.5 kg-m, 25 Ib-ft)
SEALING
WASHERS
Replace
BANJO BOLT
35 N-m (3.5 kg-m, 25 Ib-ft)
MAINTENANCE
BLEEDER
9 N-m (0.9 kg-m, 6.5 Ib-ft)
POWER UNIT
Do not disassemble
PUMP BRACKET
6 mm FLANGE BOLT
10 N-m (1.0 kg-m, 7 Ib-ft)