nsxe23294a.pdf

Cruise Control
Main Switch Replacement
CAUTION:
All SRS electrical wiring harnesses are covered with
yellow outer insulation.
Before disconnecting the SRS wire harness, install
the short connector on the airbag (see page 23-323).
Replace the entire affected SRS harness assembly
if it has an open circuit or damaged wiring.
1. Remove the dashboard lower cover and disconnect
the 2-P connectors from the floor wire harness.
SRS MAIN WIRE HARNESS
2-P
CONNECTORS LIGHTS-ON CHIME
FOOT LIGHT
DASHBOARD
LOWER COVER
2. Remove the dashboard center panel.
DASHBOAD CENTER
PANEL
3. Remove the tilt cover.
TILT COVER
4. Remove the steering column lower cover and upper
cover.
5. Disconnect the 16-P connector and the 10-P
connector.
10-P
CONNECTOR
16-P CONNECTOR
CAUTION: Be careful not to damage the SRS wires.

6. Remove the 4 screws from the lighting switch.
7. Remove the lighting switch (main switch).
LIGHTING SWITCH
10-P CONNECTOR
16-P CONNECTOR
Main Switch Test
1. Remove the dashboard lower panel and dashboard
center cover.
2. If necessary, remove the knee bolster.
3. Check for continuity between the terminals in each
switch position according to the table.
CRUISE
MAIN
SWITCH
16-P CONNECTOR
View from terminal side