nsxb13020a.pdf

Change Holder Assembly, Shift Fork
Clearance Inspection
1. Measure the clearance between the shift piece and
shift arm.
Standard: 0.05—0.25 mm
(0.002-0.010 in)
Service Limit: 0.5 mm (0.020 in)
SHIFT ARM SHIFT PIECE
2. If the clearance exceeds the service limit, measure
the width of the shift arm.
Standard: 12.9-13.0 mm (0.508-0.512 in)
SHIFT ARM
If the width of the shift arm is less than the stan-
dard, replace the shift arm with a new one.
If the width of the shift arm is within the standard,
replace the shift piece with a new one.
3. Measure the clearance between the interlock and
select arm.
Standard: 0.03-0.15 mm (0.001 – 0.006 in)
INTERLOCK
SELECT ARM
4. If the clearance exceeds the standard, measure the
width of the interlock finger.
Standard: 11.95 – 12.00 mm
(0.470-0.472 in)
INTERLOCK
If the width of the interlock is less than the stan-
dard, replace the interlock with a new one.
If the width of the interlock is within the standard,
replace the select arm with a new one.

5. Measure the clearance between the shift fork, the
5th/reverse shift piece and shift piece.
Standard: 0.2-0.5 mm
(0.008-0.020 in)
Service Limit: 0.6 mm (0.024 in)
1ST/2ND SHIFT FORK
5TH/REVERSE
SHIFT PIECE
6. If the clearance exceeds the service limit, measure
the width of the shift piece.
Standard: 11.9 – 12.0 mm (0.469-0.472 in)
SHIFT PIECE
If the width of the shift piece is less than the stan-
dard, replace the shift piece with a new one.
If the width of the shift piece is within the standard,
replace the 5th/reverse shift piece or shift forks
with a new one.
3RD/4TH
SHIFT FORK
SHIFT PIECE