Lighting System
Lighting Switch Replacement
CAUTION:
All SRS electrical wiring harnesses are covered with
yellow outer insulation.
Before disconnecting the SRS wire harness, install
the short connector on the airbag (see page 23-323).
Replace the entire affected SRS harness assembly
if it has an open circuit or damaged wiring.
1. Remove the dashboard lower cover and disconnect
the 2-P connectors from the floor wire harness.
2-P
CONNECTORS DASHBOARD
LOWER COVER
2. Remove the dashboard center panel.
DASHBOARD CENTER
PANEL
3. Remove the tilt cover.
TILT COVER
4. Remove the steering column lower cover and upper
cover.
5. Disconnect the 16-P connector and 10-P connector.
10-P
CONNECTOR
16-P CONNECTOR
Lighting Switch Replacement
CAUTION:
All SRS electrical wiring harnesses are covered with
yellow outer insulation.
Before disconnecting the SRS wire harness, install
the short connector on the airbag (see page 23-323).
Replace the entire affected SRS harness assembly
if it has an open circuit or damaged wiring.
1. Remove the dashboard lower cover and disconnect
the 2-P connectors from the floor wire harness.
2-P
CONNECTORS DASHBOARD
LOWER COVER
2. Remove the dashboard center panel.
DASHBOARD CENTER
PANEL
3. Remove the tilt cover.
TILT COVER
4. Remove the steering column lower cover and upper
cover.
5. Disconnect the 16-P connector and 10-P connector.
10-P
CONNECTOR
16-P CONNECTOR
6. Remove the 4 screws from the lighting switch.
7. Disconnect the 10-P connector from the cancel unit,
then remove the lighting switch.
Lighting Switch Light Bulb Replacement
1. Remove the steering column covers.
2. Remove the 2 screws.
3. Slide the lighting switch out of the housing as shown.
4. Remove the bulb from the lighting switch by turning
the bulb 45°.
BULB (0.91 W)
HOUSING
LIGHTING SWITCH
10-P CONNECTOR
16-P CONNECTOR CANSEL SWITCH
8. If necessary, remove the cancel unit and cancel switch.
TURN SIGNAL
CANCEL UNIT
TURN SIGNAL
CANCEL SWITCH
LIGHTING SWITCH