nsxe20039a.pdf

Seat Belts
Replacement
CAUTION: Check the seat belts for damage and replace them if necessary. Be careful not to damage them durinc
removal and installation.
NOTE: Remove the anchor bolts with a 1 7 mm socket or box-end wrench.
1. To remove the seat belts, first remove the seats (page 20-38).
NOTE: Take care not to scratch the interior trim, dashboard and center armrest.
2. Remove the cap and remove the lower anchor bolt.
3. Remove the center anchor bolt, and disconnect the connector.
4. Remove the rear pillar trim panel and side panel (page 20-37).
5. Remove the upper anchor bolt and retractor bolts.
RETRACTOR BOLT
7/16-20 UNF
32 N·m (3.2 kg-m, 23 Ib-ft)
6 x 1.0 mm
10 N·m (1.0 kg-m, 7.2 Ib-ft)
TOOTHED
LOCK WASHER
SPRING WASHER
TOOTHED
LOCK WASHER
SPRING WASHER
PROTECTOR
BAG
* CENTER AN CHOR BOLT
7/16-20 UNF
32 N·m (3.2 kg-m, 23 Ib-ft)
6. Check that the retractor locking mechanism func-
tions as described on page 20-40.
7. Installation is the reverse of the removal procedure.
NOTE:
Make sure you assemble the washers and col-
lars on the upper and lower anchor bolts as
shown.
Before attaching the rear pillar trim panel, make
sure there are no twists or kinks in the belts.
On reassembly, replace the anchor bolts (* ) and
use liquid thread lock.
TOOTHED
LOCK WASHER
* LOWER ANCHOR BOLT
7/16-20 UNF
32 N·m (3.2 kg-m, 23 Ib-ft)
SPRING WASHER
CAP
REAR PILLAR TRIM PANEL
Replacement, page 20-37
BEARING
PLAIN
WASHER
* UPPER ANCHOR BOLT
7/16-20 UNF
32 N·m (3.2 kg-m,
23 Ib-ft)
TOOTHED
LOCK WASHER