nsxe11082a.pdf

Idle Control System
Troubleshooting Flowchart Starter Switch Signal
This signals the PGM-FI ECU when the engine is cranking.
Inspection of Starter Switch
Signal. BATTERY
VOLTAGE?
C 11
A26
NOTE: Clutch pedal must be depress-
ed on M/T models.
Connect the ECU test harness
between the ECU and connector
(page 11-21).
Measure voltage between C11
(+) terminal and A26 (-) terminal
with the ignition switch in the
start position.
Is there battery voltage ? Inspect No. 7 fuse.
Is No. 7 fuse OK ? Replace fuse.
Repair open in BLK/WHT wire
between ECU (C11) and No. 7
fuse.
Starter switch signal is OK.