Side Marker/Turn Signal/Hazard Flasher System
Hazard Warning Switch Removal
CAUTION:
All SRS wiring harnesses are covered with yellow out-
er insulation.
Before disconnecting any part of the SRS wire har-
ness, Install the short connectors (see page 24-10)
Replace the entire affected SRS harness assembly if
it ha* an open circuit or damaged wiring.
1. Remove the dashboard lower cover and disconnect
the connectors from the floor wire harness.
CONNECTORS
DASHBOARD
LOWER COVER
2. Disconnect the 18-P connector from the floor wire
harness. HAZARD WARNING
SWITCH
18-P
CONNECTOR
3. Remove the tilt cover.
TILT COVER
4. Remove the steering column tower cover and upper
cover. Be careful not to damage them.
5. Remove the four screws, then remove the hazard
warning switch and wiper switch.
HAZARD
WARNING
SWITCH
WIPER SWITCH
Hazard Warning Switch Removal
CAUTION:
All SRS wiring harnesses are covered with yellow out-
er insulation.
Before disconnecting any part of the SRS wire har-
ness, Install the short connectors (see page 24-10)
Replace the entire affected SRS harness assembly if
it ha* an open circuit or damaged wiring.
1. Remove the dashboard lower cover and disconnect
the connectors from the floor wire harness.
CONNECTORS
DASHBOARD
LOWER COVER
2. Disconnect the 18-P connector from the floor wire
harness. HAZARD WARNING
SWITCH
18-P
CONNECTOR
3. Remove the tilt cover.
TILT COVER
4. Remove the steering column tower cover and upper
cover. Be careful not to damage them.
5. Remove the four screws, then remove the hazard
warning switch and wiper switch.
HAZARD
WARNING
SWITCH
WIPER SWITCH