nsxd23106a.pdf

Charging System
Alternator Overhaul
NOTE: It is only necessary to separate the pulley, drive
end housing and rotor when the front bearing needs
replacement.
Loosen the locknut with 10 mm and 22 mm wrenches
to remove the pulley from the rotor. If necessary, use an
impact wrench.
TERMINAL INSULATOR
END COVER BRUSH HOLDER
22 mm BOX
WRENCH
VOLTAGE REGULATOR
BRUSH HOLDER
INSULATOR
SPACER RING
REAR BEARING
BRUSHES
Inspection, page 23-107
DIODE (RECTIFIER) ASSEMBLY
Test, page 23-107
INSULATOR SLEEVE
BEARING RETAINER
STATOR THROUGH BOLT Do not disassemble.
STATOR ASSEMBLY/DRIVE END HOUSING
Test, page 23-108
PULLEY LOCKNUT
115 N.m
(11.5kg-m, 83 Ib-ft)
PULLEY
FRONT BEARING
ROTOR
Test, page 23-108
CAUTION: Do not get grease
or oil on the slip rings.
PULLEY
10 mm BOX WRENCH
PULLEY LOCKNUT
115 N.m (11.5 kg-m, 83 Ib-ft)
REAR HOUSING ASSEMBLY