NOTE: Remove three shafts
together.
MAINSHAFTSECONDARY
NOTE: Align the control shaft spring
pin with the groove in the transmission
housing.
SPRING
PIN
CONTROL
SHAFT
GROOVE
HOUSING PULLER
07HAC–PK4010A
2 Bolts
Transmission Housing
Removal
SHAFT
COUNTERSHAFT
Clean all parts thoroughly in solvent or carburetor cleaner and dry with compressed air.
Blow out all passages.
The (7/32) 7 steel ball in reverse idler gear shaft is under spring pressure, take care not to let it pop out.
NOTE:
1. Remove the transmission housing in the following numbered sequence.
CAUTION: Set the special tool with bolts as shown.
BOLT
together.
MAINSHAFTSECONDARY
NOTE: Align the control shaft spring
pin with the groove in the transmission
housing.
SPRING
PIN
CONTROL
SHAFT
GROOVE
HOUSING PULLER
07HAC–PK4010A
2 Bolts
Transmission Housing
Removal
SHAFT
COUNTERSHAFT
Clean all parts thoroughly in solvent or carburetor cleaner and dry with compressed air.
Blow out all passages.
The (7/32) 7 steel ball in reverse idler gear shaft is under spring pressure, take care not to let it pop out.
NOTE:
1. Remove the transmission housing in the following numbered sequence.
CAUTION: Set the special tool with bolts as shown.
BOLT