Categories
Electrical

nsxb23266a.pdf

Power Door Locks
Driver’s Door Actuator Test
1. Remove the door panel (see section 20).
2. Disconnect the 8-P connector from the actuator.
ACTUATOR
View from wide side
3. Test actuator operation:
LOCK: With battery power connected to the
No. 7 terminal, connect ground to the
No. 8 terminal momentarily.
UNLOCK: With battery power connected to the
No. 8 terminal, connect ground to the
No. 7 terminal momentarily.
CAUTION: To prevent damage to the motor, con-
nect power and ground only momentarily.
4. If the actuator fails to operate properly, replace it.
5. Check for continuity between the terminals in each
switch position according to the table.
Key Cylinder Switch:
Door Lock Knob Switch:
DOOR LOCK KNOB
KEY CYLINDER
SWITCH
DOOR
KEY

Attachments