Categories
Electrical

nsxb23264a.pdf

Power Door Locks
Control Unit Input Test
Remove the glove box, then disconnect the 18-P con-
nector from the control unit.
Inspect the connector terminals to be sure they are all
making good contact.
• If the terminals are bent, loose, or corroded, repair
them as necessary, and recheck the system.
• If the terminals look OK, make the following input
tests at the connector.
— If any test indicates a problem, find and correct
the cause, then recheck the system.
— If all the input tests prove OK, the control unit
must be faulty; replace it.
POWER DOOR LOCK
CONTROL UNIT
View from wire side

No. Wire Test condition Test: Desired result Possible cause if result is not obtained
CAUTION: To prevent damage to the motor, connect power and ground only momentarily.

Attachments