Categories
Electrical

nsxb23259a.pdf

Door Mirror Test
1. Remove the door panel, and carefully remove the
plastic cover (see section 20).
2. Disconnect the power mirror 3-P connector.
3. Test actuator operation:
TILT UP: Connect battery power to the No.
3 terminal and ground to the No. 2
terminal.
TILT DOWN: Connect battery power to the No.
2 terminal and ground to the No. 3
terminal.
SWING LEFT: Connect battery power to the No.
2 terminal and ground to the No. 1
terminal.
SWING RIGHT: Connect battery power to the No.
1 terminal and ground to the No. 2
terminal.
4. If the mirror fails to operate properly, replace it.
3-P CONNECTOR
View from terminal side
Door Mirror Replacement
1. Remove the door panel, and carefully remove the
plastic cover (see section 20).
2. Disconnect the 3-P connector.
DOOR MIRROR
MOUNTING NUTS
3. Remove the two mounting nuts while holding the
mirror.
4. Install in the reverse order of removal.
3-P CONNECTOR

Attachments